Toyota Child restraint seat - 73700-0W150 - Child restraint seat - Midi - mode d'emploi

WARNING!
[MIDI_031] When fixing the Toyota ISOFIX
BASE to the vehicle seat, ensure that both
ISOFIX connectors are set correctly and
to the same position. Check this by lightly
shaking the Toyota ISOFIX BASE, and check
that the figures on the top of the connectors
match up (or that both are blank). Failure to
observe this notice may seriously risk your
child’s safety.
Step 6
Adjust the support leg
[MIDI_032] Set the height of the support leg as
recommended in your vehicle’s owner manual,
following the instructions in Section 3 – Basic
instructions (Adjusting the support leg).
In case there is no specific installation
recommendation in your vehicle’s owner manual,
adjust it so that its base lies on the vehicle floor
and by minimizing the clearance between the seat
cushion and the ISOFIX BASE.
WARNING!
Ensure that the support leg is locked into
position, the green marking on top of the
button must be visible, and that it lies flush
against the floor. Failure to observe this
notice may seriously risk your child’s safety,
and the safety of other passengers.
! Note: Check the support leg is locked in
place by gently pushing and pulling it.
! Note: If you notice that the Toyota ISOFIX
BASE can still be moved around on the vehicle
seat, repeat all the steps in Section 4 – Use in the
vehicle (Securing the Toyota ISOFIX BASE), until
the base is firmly secured to the vehicle seat.
Securing the Lexus or Toyota MIDI in a
backwards-facing position [MIDI_033]
Step 1 Check the Toyota ISOFIX BASE
WARNING!
The Lexus or Toyota MIDI must only be
secured via the Toyota ISOFIX BASE. As
such, ensure that the Toyota ISOFIX BASE is
attached firmly and correctly to the vehicle
seat. If you notice that the Toyota ISOFIX
BASE can still be moved around, repeat all
the steps in Section 4 – Use in the vehicle
(Securing the Toyota ISOFIX BASE).
WARNING!
[Airbag Warning] NEVER fit the Lexus or
Toyota MIDI in a backwards-facing position
on the front seat with the airbag activated.
There is a SERIOUS RISK OF INJURY OR
DEATH, and it is therefore FORBIDDEN BY
LAW. Depending on the vehicle, you may be
able to deactivate the airbag yourself, or may
need to contact your local dealer/garage for
assistance.
Step 2
Lock the seat into the Toyota ISOFIX
BASE
[MIDI_034] Turn the Lexus or Toyota MIDI against
the direction of travel, and place it above the
middle of the Toyota ISOFIX BASE. Press the two
connection bolts in the foot area of the Lexus or
Toyota MIDI into the rear connection hooks of the
Toyota ISOFIX BASE. For guidance, use the
arrows on the outside of the seat and on the rear
connection arms of the Toyota ISOFIX BASE. The
bolts are properly locked into the rear connection
hooks when each one clicks into place, and you
can see a green marking on the top of each hookʼs
release element.
[MIDI_035] To secure the connection rod in the
seat area of the Lexus or Toyota MIDI with the
front connection hooks of the Toyota ISOFIX
BASE, press down from above on the back section
of the Lexus or Toyota MIDI, until you hear a click.
! Note: [MIDI_055] In backward-facing position
the shoulder pads should not be used. Open the
shoulder harness cover and remove the shoulder
pads.
8 Lexus or Toyota MIDI