Rev. 004 A BTR 185 - Quick® SpA

GBINSTALLATIONWARNING: pay particular attention to avoid interferences between the lid and the hull opening. Too precise contactswill cause damages to the entire moving system.3) Fix the actuator on the lever again, by inserting the lock pin.Once the system has been mechanically verified, proceed to adjust the limit switch.PROCEDURE FOR THE ADJUSTMENT OF THE CLOSING LIMIT SWITCH OF BTR PROPELLER.WARNING: the following procedure must be carried out by qualified personnel.WARNING: presence of moving mechanical parts. Pay extreme attention when operating on the BTR propeller ifconnected to power.4) Ensure that all electrical connections have been properly carriedout.5) Remove the cover from the card box.FIG. 8CAN2UPDWNLimit switch adjustments must be made in “manual mode”.6) Holding down both buttons on the board(fig. 8 / part. A), connectpower to the RTC R1 electronic control board until the (green)POWER LED begins flashing rapidly (fig. 8 / part. B).Then release both buttons.7) Push the “DOWN” button to open the thruster, as long as the LASTATUS LED will become green.8) Push the “UP” button to close the thruster until the ERROR LED(Red) flashes.ABCDPOWERLA STATUSERROR26RETRACTABLE THRUSTER BTR185 DP - IT GB - REV004A