1 2 - Bygghemma

Installation inside the wall cupboard1. Align the cupboard doors if the hingeswill no longer be accessible after theextractor hood has been fitted.2. Place the extractor hood onto themounting brackets and push it into thecupboard.4. Install a shelf immediately above theextractor hood. Cut holes for the pipeconnection and the mains cable.2020Important: The extractor hood must befirmly seated on the 4 mountingbrackets.3. Loosely screw in the 4 enclosed screws.Align the extractor hood and thentighten screws. Check that the extractor hood is firmlyfitted into the cupboard.mind.15mind. 475 If the shelf is permanently fixed insidethe cupboard, 4 holes must be drilled toprovide access to the 4 mounting screwsfor the extractor hood.5. Route the mains cable through the holein the wall cupboard and connect up theexhaust pipe.6. Connect up the extractor hood to themains.7. If no handle is going to be attached tothe vapour extractor, seal off the 3 holeswith the enclosed caps.13