1 2 - Bygghemma

Installation inside the wallcupboardNote: The extractor hood housing insidethe wall cupboard can be boarded up (e.g.with chipboard).Please observe the following:– The shelf must not be rest upon theextractor hood housing.– The board at the front should not beattached to the housing.– Ensure that access is possible forreplacing filters or by Customer Service.Weight in kg:Exhaust airRe-circulating air7,0 8,0The manufacturer reserves the right to make designalterations in the interests of technical development.Electrical connectionWARNING: THIS APPLIANCE MUST BEEARTHEDIMPORTANT: Fitting a Different Plug:The wires in the mains lead are coloured inaccordance with the following code:Green and Yellow – EarthBlue– NeutralBrown– LiveIf you fit your own plug, the colours ofthese wires may not correspond with theidentifying marks on the plug terminals.This is what you have to do:1. Connect the green and yellow (Earth)wire to the terminal in the plug marked‘E’ or with the symbol ( ), orcoloured green or green and yellow.2. Connect the blue (Neutral) wire to theterminal in the plug marked ‘N’ orcoloured black.3. Connect the brown (Live) wire to theterminal marked ‘L’, or coloured red.The extractor hood may only beconnected to an earthed socket that hasbeen installed according to the relevantregulations. If possible, site the earthedsocket directly above the wall cupboard orin its immediate vicinity.Electrical specifications:Are to be found on the name plate insidethe appliance after removal of the filterframe. Before undertaking any repairs,always disconnect the extractor hood fromthe electricity supply.Length of the connecting cable: 1,30 m.If it is necessary to wire the extractorhood directly into the mains:The extractor hood may only be connectedup by a qualified electrician approved bythe appropriate electricity company.A separator must be installed in thehousehold circuit. A suitable separator is aswitch that has a contact gap of more than3 mm and interrupts all poles. Suchdevices include circuit breakers andcontactors.This extractor hood complies with ECregulations relating to the suppression ofRF interference.15