ProAudio-RRMP-677 - E2 Fachhandels & Reparatur Servicecenter ...

Weitere Magazine

Empfehlungen

Info

ENGLISH 22 PREPARATION, RADIO Unpacking and checking • Remove all packaging and check the appliance for damage. • Do not use the appliance if it is damaged in any way. Bring it back to the dealer immediately. • Open the CD compartment and remove the transport protection. Battery operation • Open the battery compartment and insert six C-Cell (UM-2/LR14 type) batteries. Please observe correct polarities. The batteries are not included. • Note: When the appliance is only used with “AC“ or is not used for 4 weeks or more, please remove the batteries, to avoid damage to the appliance from leakage of batteries. • Also observe the safety instructions for handling batteries (Important safety instructions). Bottom view Headphone jack • This appliance is equipped with a stereo headphone jack (3.5mm diameter) which accepts most standard earphones & headphones (not included). • When the plug of a standard headphone or earphone is inserted into this jack, the built-in speakers will automatically be disabled. • When the headphone or earphone is disconnected, the speakers will be activated. Radio operation • Slide the function switch to RADIO. • Set the band switch to the desired band (AM or FM). • Rotate the tuning control knob to tune in to the desired station. • Adjust the telescopic antenna (for FM) or position of the set (for AM) to obtain the best reception. • Adjust the volume control knob to the desired level. • To turn off the radio, slide the function switch to TAPE (OFF). ProAudio-RRMP-677-IM-DE-EN-V1.indb 22 28/05/2010 3:35 PM
CD-PLAYER Inserting and removing a CD • When opening the CD compartment always ensure the disk is not in motion (not spinning). Always press CD STOP key to stop the disk spinning first. • Place a CD into the compartment with the label-side (printed side of disk) facing upwards. Press down in the center part of the disk until the disk locks onto the center spindle. • When the CD has been placed onto the center spindle, gently lower the CD door downwards until it locks shut. The CD is now ready to be played. • To remove a disk, follow the same procedure as described above. Remove the CD by placing one finger at the middle of disk (center spindle) and the other at the edge of the disk and gently pull upwards. • Note: Always hold a CD by its edges. Avoid getting any finger prints, smudges or dirt onto the surface of a disk. In case this happens, use a special CD cleaning cloth or cleaning kit to remove the dirt or smudges. Playback CDs • Insert a CD as described. • Slide the function switch to CD. The CD will spin momentarily and then the display will show the total number of tracks of the disk. • Press the CD PLAY/PAUSE key. The disk will start spinning and the first track will start playing. The display will indicate the current track number, e.g. 02 if it is the second track. • At any time during playback press the CD PLAY/PAUSE key to pause operation of the unit. Press the CD PLAY/PAUSE key again to resume operation at the same track and position. At any time during playback, press the CD STOP key to stop playback. This will reset the CD player to the first track. If you press the CD PLAY/PAUSE key, the first track will always start playing. • At any time during playback, press and release the CD NEXT key or CD BACK key to skip forwards or backwards by one track, as desired. • At any time during playback, press and hold the CD NEXT key or the CD BACK key to fast-forward (cue) or fast-reverse (review) the specific track, which is currently playing. Notes: • Make sure the CD has completely stopped spinning before opening the CD compartment. • Remove the disk from the compartment only when the disc compartment is fully open. • Never place more than one disc into the disc compartment at any time. • Do not put anything except a CD into the compartment. Foreign objects can damage the mechanism. • Impacts to the device can cause it to skip CD tracks. • Very high sound levels can cause the device to skip tracks due to vibration. Very high sound levels can cause loss of hearing and should therefore be avoided. • Keep the disc compartment closed when not in use to prevent dirt and dust from entering the mechanism. ProAudio-RRMP-677-IM-DE-EN-V1.indb 23 28/05/2010 3:35 PM 23 ENGLISH
Seite 1 und 2: CD Radio Rekorder CD Radio Recorder
Seite 3 und 4: Erklärung der Warnsymbole WICHTIGE
Seite 5 und 6: WICHTIGE SICHERHEITSANWEISUNGEN Kon
Seite 7 und 8: VORBEREITUNG, RADIO Auspacken und K
Seite 9 und 10: Wiederholungs-Funktion • Drücken
Seite 11 und 12: Löschschutz • Sie können Kasset
Seite 13 und 14: PROBLEMLÖSUNG Wenn ein Fehler auft
Seite 15 und 16: Kunden Info Herstellergarantie Wir
Seite 17 und 18: TABLE OF CONTENTS TABLE OF CONTENTS
Seite 19 und 20: IMPORTANT SAFETY INSTRUCTIONS Insta
Seite 21: 3 2 1 16 15 14 13 12 11 17 CONTROL
Seite 25 und 26: CASSETTE RECORDER Playback cassette
Seite 27 und 28: CLEANING AND CARE Sound head cleani
Seite 29 und 30: Power supply AC 230V~, 50Hz Battery
Seite 31: Customer Info Manufacturer’s Warr

ProAudio-RRMP-677 - E2 Fachhandels & Reparatur Servicecenter ...

Erfolgreiche ePaper selbst erstellen

Template löschen?

Als Template speichern?