Steuergerät BS 5161 Druckerhöhungsanlangen - Biral

Deutsch
13. Einstellungen Parameter HP-E Pumpe
1.Alarm
Restart at MCP/MPF Alarm Yes Indicate MCP/MPF Alarm Yes
Restart at Current Alarm Yes Indicate Current Alarm Yes
Restart at Temperature Alarm Yes Indicate Temperature Alarm Yes
Restart at Voltage Alarm Yes Indicate Voltage Alarm Yes
Restart at HSD Alarm Yes Indicate HSD Alarm Yes
Restart at Extemal Fault No Indicate Extemal Fault Yes
Restart at Sensor/S-p. Fault Yes Indicate Sensor/S-p. Fault Yes
Restart at Remaining Alarm No Indicate Remaining Alarm Yes
Aut. Restart Active Yes Relay Setup Ready
Reset Alarm at Start Yes RelayFilter (sec.):
2.Protection
Stop at Sensor Fault
Min. at Extemal Set-point Fault
Reduce Freq. in case of overload
3.Input/Output
Digital Input Function 1 Start Analog output: Setpoint
Digital Input Function 2 Max.
Digital Input Function 3 Typ MGE Buttons Locked Yes
4.Converter
Ramp Up Time (s): Typ Upper Frequency (Hz) 50
Ramp Down Time Typ
Skipband 1 Top (Hz):
Minimum Frequency (%): Typ Skipband 1 Bottom (Hz):
Maximum Frequency (%): 100 Skipband 2 Top (Hz):
Skipband 2 Bottom (Hz):
Start On The Run Clockwise Rotation Yes
5.Pump
Stop Function Enabled No
Max. Time Between Flowdetec. (s): 120 Start/Stop Pressure Band (%): 10
Flow Estimation Limit 96 Boost Band Percentage (% ): 50
Dry-running Detection Enabled Yes
6.Set-point
Set-point (%): 100 Operation Mode Normal
Extern Setpoint Signal 0 – 10V
Stop from External Setpoint NO Inverse Signal No
7.Controller
Proportional Gain 0.50 Control Mode Not Controlled
Integral Time (s): 0.50 Direct Control
8.Sensor
Analog Sensor Signal Inactive Sensor Unit bar
Grundfos Sensor Inactive Max Value 0
Diverse
Min Value 0
Pumpentypen abhängige Einstellungen Typ
- 25 -