VC-G20SM VC-G200SM VC-G201SM VC-G401SM - Cenatel

VC-G20SM/G200SM
VC-G201SM/G401SM
4-23 INSTALLING THE MASTER CAM (AT
REAR SIDE OF MECHANISM CHASSIS)
1. Make sure beforehand that the shifter is at initial position.
(Right side from bottom view)
2. Place the master cam in the position as shown below.
3. Fix the E ring.
4-24 REPLACEMENT OF LOADING MOTOR
• Removal
Apply grease
*Apply grease to
the tip as well.
Worm gear
E-ring
Apply grease
Leading connect gear.
Apply grease
Loading
motor.
Worm wheel gear.
Apply grease
Red
Wire
+ : Red
- : White
Insert
L-M-Block.
Figure 4-38-1.
4. Adjust the master cam and pinch drive cam, fix the
synchro gear in correct position.
Note:
See the figure below for the phase matching between the
master cam synchro gear and pinch drive cam.
Figure 4-39.
• Replacement
Remove the loading motor, and install the replacement
loading motor as shown below.
Worm gear
+0
6.95 mm
-0.15
Pinch Drive Cam
Loading
motor
Synchro
gear
Phase
matching
Hole of Pinch Drive Cam
Master Cam
To press the motor in, first
receive it by portion A.
Figure 4-40.
A part
The loading motor pressing-in must be less than 196N (20
kgf).
Adjust the distance between motor and pulley to 6.95
+0. 2
mm.
–0.15
Figure 4-38-2.
24