SK 204, SK 204 T Standkonvektor - AEG Haustechnik

For the User
14
A For objects of all kinds, such as for example furniture, drapes, curtains and textiles or other flammable or
non-flammable materials, the following minimum distances from the unit, particularly from the air outlet grille,
must be observed:
In front of the air outlet grille 500 mm
Above the air outlet grille at a Overhang < 00 mm 500 mm
Side of unit 150 mm
Rear of unit 0 mm
The hot air must be able to exit freely!
No articles must fall, hang, lay or stick into any opening of the appliance (e.g. necklaces a.s.o.). This can lead
to deadly current draws and/or fires.
Do not use the appliance as a stool!
No changes at the equipment must be made.
Never leave the alliance when in use unsupervised. Remote switches or automatic engaged equipment or
upstream components are not allowed with this appliance. (e.g. ambient temperature automatic controller) is
not permitted.
Special caution is required, if the appliance is used in the presence of children, invalid persons or animals. Danger
of injury!
If a part of the appliance is damaged or has fallen down or it was already defect/malfanctioning, it may no be
taken in to operation.
1.4 Care and maintenance
Before cleaning or maintenance the power supply plugs of the appliance must pulled out of the socket and it
must cool down first!
If slight brownish discolouration should appear on the unit housing, this should be rubbed off as soon as possible
with a damp cloth.
The unit should be cleaned in the cold condition, using customary cleaning agents.
Abrasive or corrosive cleaning agents should be avoided.
Humidity may not penetrate into the equipment.
Do not spray any cleaning sprays into the air slots.
The appliacne must be well dried before it is taken in operation!
The appliance should be kept free of dust and vibrations and must be kept well protected.
What to do if . . . ?
• the unit does
not get hot?
• the unit switches
itself off?
• customer service
is called?
Check that . . .
. . . the ON/OFF switch is turned on.
. . . in your fuse box, the corresponding fuse is intact or whether the breaker has tripped.
Eliminate cause!
If the heater still does not warm up, call an engineer!
Check whether it is covered, so it could have overheated (e.g. covered air outlet or inlet opening).
Eliminate cause!
If it does not warm up again after a few minutes‘ cooling down period, call an engineer!
Read the model (Modell) and E- and F-number from the rating
plate (8) on the unit and tell customer service!
Modell: SK . . . .
E-Nr.: . . . . . .
F-Nr.: . . . . . . . .
Made in E.C.