SCRUBTEC 545E – 553E - Wapalto-heine.de

ENGLISH
USER MANUAL
USE
WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.
BEFORE MACHINE START-UP
Brush/pad-holder installation/removal
1. Disconnect the power supply cable (3) from the electrical mains.
2. Place the brush (A, Fig. 1) or the pad-holder (B) under the deck (14).
3. Lower the deck on the brush/pad-holder by pressing the pedal (8).
4. Connect the power supply cable (3) to the electrical mains.
5. Press the switch (51) to turn on the machine and the accessories.
6. Press one of the switches (55) to engage the brush or the pad-holder.
WARNING!
Do not press the switches (55) too much, otherwise the machine will start.
7.
To remove the brush/pad-holder lift the deck by pressing the pedal (8), then manually remove the brush/pad-holder from the
hub, by turning it in the opposite direction to the normal rotation direction.
Figure 1
Types of brushes available
450 mm-models 530 mm-models
PROLENE
PROLENE
MIDLITE GRIT 180 MIDLITE GRIT 180
MIDGRIT 240 MIDGRIT 240
PROLITE
PROLITE
UNION MIX
UNION MIX
S311334
10 SCRUBTEC 545E – 553E 9097056000(2)2009-06 A