SCRUBTEC 545E – 553E - Wapalto-heine.de
SCRUBTEC 545E – 553E - Wapalto-heine.de
SCRUBTEC 545E – 553E - Wapalto-heine.de
Erfolgreiche ePaper selbst erstellen
Machen Sie aus Ihren PDF Publikationen ein blätterbares Flipbook mit unserer einzigartigen Google optimierten e-Paper Software.
USER MANUAL<br />
ENGLISH<br />
VACUUM SYSTEM MOTOR FILTER CLEANING<br />
1. Drive the machine on a level fl oor.<br />
2. Disconnect the power supply cable (3) from the electrical mains.<br />
3. Remove the recovery water tank retaining plate (36).<br />
4. Open the recovery water tank.<br />
5. If necessary, drain the water from the tank in or<strong>de</strong>r to make the fi lter visible.<br />
6. Check that the pre-fi lter is clean. If necessary clean it with water and compressed air, then install it.<br />
7. Perform steps 1, 2, 3 and 4 in the reverse or<strong>de</strong>r.<br />
SOLUTION/CLEAN WATER FILTER CLEANING<br />
1. Drive the machine on a level fl oor.<br />
2. Disconnect the power supply cable (3) from the electrical mains.<br />
3. Close the solution tap (A, Fig. 5) un<strong>de</strong>r the machine, behind the right rear wheel. The tap (A) is closed when it is in the position<br />
(B) and it is open when it is in the position (C).<br />
4. Remove the transparent cover (D), then remove the fi lter strainer (E). Clean and install them on the support (F).<br />
NOTE<br />
The fi lter strainer (E) must be correctly positioned on the housing (G) of the support (F).<br />
5.<br />
Open the tap (A).<br />
A<br />
G<br />
E<br />
F<br />
E<br />
C<br />
B<br />
D<br />
Figure 5<br />
P100109<br />
9097056000(2)2009-06 A <strong>SCRUBTEC</strong> <strong>545E</strong> <strong>–</strong> <strong>553E</strong> 17