MANUAL - TermaTech

FUNCTION/SETTINGSFunction description/settingsThermostatThe Celsius is fitted with an integrated electronicthermostat. This starts the fan when the temperatureexceeds the preset value. The fan can beadjusted to start at between 16 and 30 degrees.The factory setting for the starting point is approx.25°C. The starting point can be easily adjusted usingthe plus and minus keys (TEMP) on the controlpanel. The starting point is indicated by the LEDlamps on the thermometer scale. Even degrees areindicated by ONE lamp lighting before the desirenumber of degrees. Uneven degrees are indicatedby TWO lamps lighting next to the desired numberof degrees. For example, if 25 degrees is required asa stating point, use the plus and minus keys (TEMP),until lamps 24 AND 26 light up.When the thermostat activates the fan, the yellowindicator lamp lights up.Before the starting point is adjusted, the fan must beconnected to the mains for at least 15 minutes. Thisis because the fan's electronics must first of all reachoperating temperature.RPM settingsThe fan speed can be adjusted between approx. 700rpm and the max. speed, which is approx. 2,200 rpm.The settings are easy to adjust using the plus andminus keys (SPEED) on the control panel.Every speed increment from 1 to 7 increases thecapacity by approx. 10%.The upper speed setting (8) has a boost functionthat increases the capacity by 30% to max.Speed indication takes place using a column of LEDlamps on a scale of 1 to 8.If you adjust the speed down to zero (no lamp is lit),the thermostat function is deactivated completely.10