1 - 3D Air Sales Ltd.

Operation and indication section for remote controlOperation sectionFAN SPEED buttonEach time the button is pushed, the indicatoris switched over in turn.HI POWER buttonThis button changes the HI POWER mode.Page 9AIR FLOW buttonThis button changes the flap mode. Whenpressed, this button changes the mode in thefollowing order:AUTOHIMEDLOHI POWERFAN SPEED ONHI POWER TEMPAIR FLOWONAMOFFECONOPMOFFMODEECONOOPERATION MODE select buttonEach time the button is pushed, the indicatoris switched over in turn.ON/OFF buttonPress for starting operation, press again forstopping.ECONOMY buttonThis button changes the ECONOMY mode.Page 9(Air scroll)(SWING)Page 10TIME CANCELON OFF RESERVETIMERTIMEACLTEMPERATURE buttonThis button sets the room temperature.(This button changes the present time andTIMER time.)ON TIMER buttonThis button selects ON TIMER operation.Page 12Clock switchThis switch for setting the clock.Page 11OFF TIMER buttonThis button selects OFF TIMER operation.Page 11• The above illustration shows all controls, but in practiceonly the relevant parts are shown.CANCEL buttonThis button cancels the ON timer and OFFtimer.RESERVE buttonThis button sets the present time andTIMER time.RESET switchSwitch for resetting microcomputer.Page 13Indication sectionHI POWER MODE indicatorIndicates during Hi power mode operation.TEMPERATURE IndicatorIndicates set temperature.(Does not indicate temperature when operationmode is on AUTO)AUTOHIMEDLOHI POWERONAMECONOPMOFFECONOMY MODE indicatorIndicates during economy mode operation.OPERATION MODE IndicatorIndicates selected operation with lamp.[ (Auto) • (Cool) • (Heat) • (Dry)]Clock IndicatorFAN SPEED IndicatorIndicates present time or timer setting time.Indicates set air flow rate with lamp.OFF TIMER IndicatorAIR FLOW IndicatorIndicates during OFF TIMER operation.Shows selected flap mode.ON TIMER IndicatorIndicates during ON TIMER operation.Transmission procedureWhen each button on the remote control is pressed – with the remote control pointing towards the air conditioner unit – a signal is transmitted.When the signal is received correctly, the unit will beep.–7–