Montageanleitung - Hansgrohe
Montageanleitung - Hansgrohe
Montageanleitung - Hansgrohe
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Operating/servicing EL40 (EL = electronic version)<br />
Motor adjustment<br />
The motor should be adjusted<br />
after the Shower Temple has<br />
been put into operation to<br />
adapt it to local home<br />
conditions. These depend on<br />
the type of heating used and<br />
the available warm water<br />
temperature.<br />
Attention: These specifications<br />
can change later when<br />
a heating system is installed<br />
or modified, or the water<br />
temperature is changed.<br />
…and it is as simple<br />
as this:<br />
The Shower Temple must be in<br />
"stand-by" mode (display has<br />
background lighting, no functions<br />
are active). The hand<br />
shower is activated automatically<br />
during motor adjustment.<br />
First press the >42° ( )<br />
button as well as the Body<br />
shower ( ) button until<br />
tCH is displayed.<br />
Now press the Mode-button<br />
( ): Motor adjustment now<br />
runs automatically. It takes about<br />
7 minutes.<br />
Pressing the Mode ( )<br />
button saves the motor<br />
adjustment.<br />
The letter C is displayed when<br />
motor adjustment has finished.<br />
Light on/off<br />
The shower lighting can be<br />
switched on and off with the<br />
Light ( ) button.<br />
Attention:<br />
Water emerges: Therefore<br />
check the position of the<br />
hand shower!<br />
Pressing the >42° ( )<br />
button stops motor adjustment<br />
prematurely (the last valid<br />
factory setting curve is then<br />
applicable).<br />
The lighting switches off<br />
automatically after the shower.<br />
Factory setting: 2 minutes;<br />
individually adjustable<br />
1 – 50 min (refer to Page 50)<br />
47<br />
English