AuV - Uni Standard P2 - Layher

More documents

Recommendations

Info

4. Insert diagonal braces 18 and an access deck 23. The diagonal braces must be installed in a tower-like (zig-zag) form on both sides. 5. Climb up to the next level and fit additional rear guardrails 15 to the second rung above the platform surface. 14 Completion of working platform All tower models 1. To complete the working platform, attach toe boards with claw 28 and end toe boards 29. If an intermediate platform is also to be used as a working platform, attach toe boards here too. Operating the castors During assembly and while working, keep the castors locked by pressing down the brake lever labelled STOP. When the brake is locked, the lever labelled STOP is in the down position. For movement, unlock the castors by pushing the opposite lever down.
max. 15 cm max. 15 cm Adjustment of the mobile beam 1 5 Models: 1401108, 1401110 K M S Maximum spindle adjustment of the various models Assembly with 1323.180 max. 40 cm Models: 1401102, 1401104, 1401106 Assembly with 1323.320 max. 40 cm max. 60 cm V max. 30 cm Models: 1401103, 1401105 max. 60 cm The adjustable mobile beam 5 permits operation in the centre position and at the wall without dismantling the scaffolding. It can be retracted and extended in the assembled state. Ensure before adjustment the ballast weights specified in the ballasting table are always attached at the right place (see pages 8 –10). For adjustment in the assembled state, lower the central support M attached to the mobile beam 5 as far as possible and secure it. Relieve the castors 1 at the sliding parts by turning the spindle S until the adjustment part V can be adjusted when the clamping wedge K has been loosened. After adjustment, fix the clamping wedge K, subject the castor 1 to load again by turning the spindle, and move the central support M upwards and secure it. max. 30 cm Models: 1401109, 1401111 Assembly directly on castors with access ledger max. 20 cm max. 40 cm Models: 1401101 (access ledger add. required) 1401124 – 1401131 1401145 – 1401151 Assembly directly on castors 0 cm Model: 1401101 max. 40 cm 15
Page 1 and 2: Layher Rolling Towers - Uni Standar
Page 3 and 4: } NOTE The products or assembly var
Page 5 and 6: 12. It is not permitted to push aga
Page 7 and 8: How the Layher advance guardrail sy
Page 9 and 10: } TOWER MODELS WITH STABILIZERS, EX
Page 11 and 12: } 5. ASSEMBLY Safety Structure P2 O
Page 13: Basic assembly Tower models 1401125
Page 17 and 18: } 7. ASCENT VIA SUSPENDED LADDER Th
Page 19 and 20: Additional requirement for special
Page 21 and 22: Assembly off-set: L l r R L l r L l
Page 23 and 24: Example for assembly, model 1401104
Page 25 and 26: } 11. WALL SUPPORT (under load) ANC
Page 27 and 28: } 13. COMPONENTS OF THE SYSTEM 1 2
Page 29 and 30: 24 25 26 27 28 29 1241.285 Deck 2.8
Page 31 and 32: } 15. IDENTIFICATION SIGN Identific

AuV - Uni Standard P2 - Layher

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?