ESP-LXME Controller Installation/Operation Guide - Rain Bird
ESP-LXME Controller Installation/Operation Guide - Rain Bird
ESP-LXME Controller Installation/Operation Guide - Rain Bird
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Set Watering Start Times<br />
Start times are the time(s) of day that the program begins.<br />
You can assign up to eight Start Times per day to a single program.<br />
Multiple Start Times allow you to run a program more than once on<br />
each day. For example, if you’re growing new lawn seed, you may want<br />
to water several times a day to keep the seedbed or top dressing damp.<br />
bb NOTE: Start times apply to the entire program and not just to an<br />
individual station.<br />
Turn the controller dial to Set Watering Start Times.<br />
gb 16 <strong>ESP</strong>-<strong>LXME</strong> <strong>Controller</strong><br />
A<br />
bb B<br />
The Set Start Times screen appears. Press the + and – buttons on<br />
the left to set Start Time for the current program.<br />
lbPress and HOLD buttons to accelerate settings for hours and<br />
minutes.<br />
NOTE: If the desired program is not selected, use the Program<br />
Select switch to change it. See Section B, Program Select Switch<br />
for more details.<br />
Press the + and – buttons on the right to set the start number (1<br />
through 8).<br />
1 2<br />
eb Change the Program Select switch and repeat this process to set<br />
up additional Watering Start Times for other programs as desired.<br />
bb NOTE: Cycle+SoakTM is an alternative method of dividing the<br />
total Station Run Time into smaller cycle times. If you plan to use<br />
Cycle+Soak, only a single Watering Start Time is required for each<br />
program. See Section D, Set Up Cycle+Soak for more details.