opel-vauxhall

Model: Corsa-BICombo 1,411,6 Tigra 1,411,6
Astra-F 1,411,6/1,812,0 Astra-G 1,4/1,611,812,0
Vectra-B I,G/l,8/2,O
Zafira 1,611,8
Omega-B 2,O
Year: 1994-00
Engine code: C14SEL, CIGSEL, C18SEL, CZOSEL, X14SZ,
X14XE, XIGSEJ, XIGSZR, XIGXE, XIGXEL, X18E1,
X18XE, X18XE1, X2OXEV
System: Multec Simtec 56.5170
General information
0 Refer to the front of this manual for general test conditions,
terminology, detailed descriptions ofwiring faults and a
general trouble shooter for electrical and mechanical faults.
Trouble codes are displayed by the malfunction indicator
lamp (MIL).
The ECM fault memory can also be checked using
diagnostic equipment connected to the data link connector
(DLC).
Accessing
NOTE: Models without a terminal in position 6 of the l6pin DLC
do not display trouble codes using the MIL. Diagnostic
equipment required.
Ensure ignition switched OFF.
Bridge data link connector (DLC) terminals 6 and earth m.
Switch ignition ON.
Trouble codes will be displayed in groups of flashes.
Count MIL flashes. Note trouble codes. Compare with
trouble code table.
Each trouble code consists of four groups of one or more
flashes.
The first group of flashes indicate the 'thousands' of the
trouble code H [A].
The second group of flashes indicate the 'hundreds' of the
trouble code H [Bl.
The third group of flashes indicate the 'tens' of the trouble
code H [C].
The fourth group of flashes indicate the 'units' of the trouble
code H [Dl.
OPEL-VAUXHALL
Engine management/transmission 1
Ten flashes in a group indicate '0'.
A short pause separates each trouble code group H [El.
A long pause separates each trouble code H [F].
For example: Trouble code Pllll displayed H.