Rapier Marshals Handbook - Midrealm / Middle Kingdom
Rapier Marshals Handbook - Midrealm / Middle Kingdom
Rapier Marshals Handbook - Midrealm / Middle Kingdom
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Rev. 2.0<br />
20 th of July, A.S. XXXV<br />
2-5<br />
D. BROKEN FOIL FOUR THRUST TEST<br />
Puncture-Resistant Material may be tested by conducting a Broken Foil Four-Thrust Test. Lay the<br />
material to be tested on a penetrable surface such as the ground or a block of ethyl foam (used for<br />
archery targets). Generally, the section to be tested should be on a spot not normally subject to attacks<br />
(i.e. the back, the inside, etc.). This will prevent excessive wear from taking place. However, if the<br />
marshal observes a worn or weakened spot in the material, the test shall take place in that location<br />
instead. Holding the broken foil in both hands, punch the material four times, in approximately the<br />
same location each time, increasing the force each time. After each punch, examine the material. If it<br />
has been completely penetrated, or seriously damaged, it fails. If there is no damage, or if only the top<br />
layer has been damaged, it passes. Note that the test blade should be at least 24 inches in length and<br />
have a typical "flat" break, not a jagged point.<br />
E. MASK PUNCH TEST<br />
Face Protection may be tested by using a standard commercial 12 kg mask punch. <strong>Marshals</strong> doing the<br />
testing shall be trained in the use of the punch. The <strong>Kingdom</strong> <strong>Rapier</strong> Marshal will designate certain<br />
marshals to administer such testing.<br />
END OF MIDDLE KINGDOM STANDARDS FOR PROTECTIVE GEAR<br />
SECTION 3<br />
MARSHALING GUIDELINES