P A T R I O T Wood Stove - Lopi
P A T R I O T Wood Stove - Lopi
P A T R I O T Wood Stove - Lopi
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
16 <strong>Stove</strong> Installation (for qualified installers only)<br />
Hearth <strong>Stove</strong> Direct<br />
Connection<br />
NOTE:<br />
Direct connections require<br />
installation of an airtight,<br />
non-combustible block-off<br />
plate or damper adapter.<br />
Interior or Exterior<br />
Masonry Chimney<br />
NOTE:<br />
This type of installation<br />
requires a UBC approved<br />
masonry connector or a<br />
factory built (U.L. Listed)<br />
wall thimble.<br />
NOTE: The entire fireplace,<br />
including chimney, must be clean<br />
and not cracked or damaged.<br />
Any damage must be repaired<br />
prior to installation of the insert.<br />
Chimney must be at least 15' tall<br />
and no greater than 33' tall.<br />
Entire fireplace, including<br />
chimney, must meet local<br />
building requirements.<br />
Combustible Mantle<br />
Floor Protection<br />
(See the section<br />
"Floor Protection<br />
Requirements" for<br />
more details)<br />
Min. 18"<br />
NOTE: The chimney must have a<br />
clay tile liner. If it does not, the<br />
installation must use a positive<br />
connection (full reline). The<br />
entire fireplace and chimney must<br />
be clean, undamaged, and meet<br />
all local building codes (UBC,<br />
etc.). Damage must be repaired<br />
prior to installation. The chimney<br />
must be 15' to 33' tall.<br />
See the section "<strong>Stove</strong><br />
Placement Requirements" for<br />
minimum clearances required.<br />
Chimney connector sections<br />
See the section<br />
"Floor Protection<br />
Requirements"<br />
<br />
<br />
Min. 18"<br />
clearance<br />
to ceiling<br />
Block-off plate or<br />
damper adapter<br />
Flue Liner<br />
Stainless steel<br />
chimney connector<br />
must Extend 1' past<br />
the block-off plate<br />
or to the flue liner<br />
Remove<br />
damper<br />
or wire it<br />
open<br />
Airtight<br />
Insulated<br />
Clean-Out<br />
See the section<br />
"<strong>Stove</strong> Placement<br />
Requirements" for<br />
minimum clearances<br />
required.<br />
Clay Liner<br />
Make sure the<br />
clean-out seals in<br />
place.<br />
Figure 16<br />
This type of<br />
installation requires<br />
a UBC approved<br />
masonry connector<br />
or a factory built<br />
(U.L. Listed) wall<br />
thimble.<br />
Figure 17<br />
© Travis Industries 93508039 4040820