BMS N54 / N55 Oil Catch Can - BurgerTuning.com

ePAPER READ

DOWNLOAD ePAPER

burgertuning.com

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

START NOW

9) Finally insert the hoses on to the BMS OCC. The UBEND hose should connect to the

connection furthest away from the firewall as shown. If you find the hoses are too long at this

point you can remove and trim them. No clamps are required.

the JB3 pin out install - Burger Motorsports

Power Box 325i / 328i / 528i Installation Guide - Burger Motorsports

Juice Box Stage 4 PnP - Burger Motorsports

JB N55 Stage 1 and Stage 2 Install Guide

8) Remove the rear diverter valve line by twisting the gray lock and pulling the tube out so it moves around freely. Only one end needs to be removed. When complete your engine bay should look like this with two hoses ready to connect to the oil catch can.

9) Finally insert the hoses on to the BMS OCC. The UBEND hose should connect to the connection furthest away from the firewall as shown. If you find the hoses are too long at this point you can remove and trim them. No clamps are required.

Page 1: BMS N54 / N55 Oil Catch Can Install
Page 4 and 5: 6) Push the UBEND over the OEM nipp
Page 8 and 9: 10) Holding the DV line out of the
Page 10: 13b) If the car is out of warranty
Page 13: N55 Install Directions: With N55 mo

BMS N54 / N55 Oil Catch Can - BurgerTuning.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?