ECL Comfort 110 Application 116 Constant temperature control of ...

How to navigate?
What do the symbols mean?
Adjust temperatures and values.
Switch between menu lines.
Select / return.
2 sec.
Return to daily user menu.
The desired flow temperature is influenced by for example return temperature.
The actuator closes the control valve.
The actuator opens the control valve.
The actuator does not activate the valve.
The pump is ON.
The pump is OFF.
The controller is in setback mode.
The controller is in pre-setback mode (the symbol is blinking).
The controller is in comfort mode.
The controller is in pre-comfort mode (the symbol is blinking).
Safety Note
To avoid injury of persons and damages to the device, it is absolutely necessary to read and
observe these instructions carefully. The warning sign is used to emphasize special conditions
that should be taken into consideration.
This symbol indicates that this particular piece of information should be read with
special attention.
VI.KT.F1.02 © Danfoss 05/2007 DH-SMT/DK
Table of Contents
Line Page
Introduction .................................................................................................. 6
Settings overview 7
Daily use ........................................................................................................ 8
Temperatures 8
Select control mode 9
Set your personal schedule 9
Maintenance ............................................................................................... 11
Date - time 1000 11
Flow temp. (flow temperature control) 2000 11
Temp. min. (flow temp. limit, min.) 2177 11
Temp. max. (flow temp. limit, max.) 2178 11
Return T limit (return temp. limitation) 4000 12
Limit (return temp. limitation) 4030 12
Gain - max. (return temp. limitation - max. influence) 4035 13
Gain - min. (return temp. limitation - min. influence) 4036 14
Intgr. time (time constant for return temp. limitation) 4037 14
Control param. (control parameters) 6000 15
Auto tuning 6173 15
Motor prot. (motor protection) 6174 16
Xp (proportional band) 6184 16
Tn (integration time constant) 6185 16
M1 run (running time of the motorized control valve) 6186 16
Nz (neutral zone) 6187 17
Application 7000 18
P1 exercise (pump exercise) 7022 18
M1 exercise (valve exercise) 7023 18
P1 frost T (frost protection) 7077 18
P1 heat T (heat demand) 7078 18
Standby T (standby temperature) 7093 19
Ext. (external override) 7141 19
Min. on time (min. activation time gear motor) 7189 19
Daylight (daylight saving time changeover) 7198 20
ECL address (master / slave address) 7199 20
Type 7600 21
Service 8000 22
Code no. 8300 22
Ver. (version no.) 8301 22
Backlight (display brightness) 8310 22
Contrast (display contrast) 8311 22
Language 8315 23
MOD address (MODBUS address) 8320 23
DH-SMT/DK VI.KT.F1.02 © Danfoss 05/2007