ATR2100-USB - Audio-Technica

More documents

Recommendations

Info

Preliminary setup with Windows XP (Service Pack 2; other operating systems may vary slightly) 1. Plug the free end of the USB cable into the USB port on your computer. The microphone’s blue LED will illuminate, indicating the mic is receiving power. Your computer will automatically recognize the USB device and install a driver. 2. In the lower right portion of your screen you may see a message that new hardware was found; or you may see a driver software installation notice. 3. To select the ATR2100-USB as your default recording device, begin at your Start menu. Select Control Panel. 6
4. Select Sounds and Audio Devices. 7
Page 1 and 2: OFF ON ATR2100-USB Instruction Manu
Page 3 and 4: 8 6 7 9 5 OFF 4 ON 3 ATR2100-USB 1.
Page 5: 3. Next, click Sound to display the
Page 9 and 10: Microphone ATR USB Mic Working Prel
Page 11 and 12: 4. Select Sound. 5. The following s
Page 13 and 14: Additional Information Using headph
Page 15 and 16: This product is warranted in the U.

ATR2100-USB - Audio-Technica

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?