Inspection Manual (Motorcycle & Moped) - Vermont Department of ...
Inspection Manual (Motorcycle & Moped) - Vermont Department of ...
Inspection Manual (Motorcycle & Moped) - Vermont Department of ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SECTION 7 – LIGHTING AND ELECTRICAL SYSTEMS<br />
All headlamps must be <strong>of</strong> an approved type.<br />
HEADLAMP TESTING<br />
Beams may be inspected for specific aim by using one <strong>of</strong> the following methods, if<br />
deemed necessary:<br />
Approved screen, placed twenty-five feet (25’) in front <strong>of</strong> the headlamp;<br />
Approved photoelectric testing machine that will give essentially equivalent results.<br />
One (1) lamp is required; not more than two (2) are permitted.<br />
Procedure:<br />
HEADLAMP ADJUSTMENT<br />
Adjust headlamp until hot spot on high beam is aimed straight ahead and dropped the<br />
following distance in twenty-five feet (25’).<br />
Single and double filament lamp – Two-inch (2”) drop in twenty-five feet (25’).<br />
All headlamps shall show a clear white light and no colored headlamp lens shall be<br />
permitted.<br />
Beam indicators are required on all motor driven cycles with a double filament lamp<br />
to indicate high or low beam.<br />
Procedure:<br />
ADDITIONAL LIGHTING EQUIPMENT – MANDATORY<br />
Inspect for condition, operating, wiring and switching.<br />
1. Inspect tail lamps.<br />
a. At least one (1) is required; two (2) are permitted.<br />
b. Must be <strong>of</strong> approved type.<br />
c. Must be red in color.<br />
MDC 7.1