Inspection Manual (Motorcycle & Moped) - Vermont Department of ...

4. Turn signal system:
a. If equipped, two (2) lamps permitted visible from the front and two (2) lamps
visible from the rear.
b. Must be of approved type.
c. Lamps showing to the front must be amber or white in color.
d. Lamps showing to the rear must be red or amber in color.
e. May be Class A or Class B.
5. Hazard warning lights:
a. If equipped, lamps must be of approved type.
b. Must flash front and rear turn signals simultaneously.
Reject vehicle if:
1. Lamps not mounted securely to prevent excessive vibration, bad wiring, improper
ground or bad switch.
2. Inoperative dimmer switch on double filament headlamp.
3. Dimmer switch in an unnatural location.
4. Beam indicator, if installed, not operational.
5. Any cause listed under headlamp above, when applicable.
6. Any required reflector, lamp or lens that is turned or inclined so that its light is not
properly directed.
7. Any signal lamp, pilot lamp, or operating unit not functioning properly.
8. Any signal-operating unit canceling mechanism not functioning properly.
9. Switches and operating units not in good condition and functioning properly.
10. Wiring in poor condition, improperly installed or insulated and so located as to incur
damage.
11. Any connection that is not secure or shows signs of excessive corrosion.
MTC 7.4