AutoTrac Universal Addendum - StellarSupport - John Deere

Operator Presence Select a seat switch or operator
activity monitor to detect operator presence.
Disengagement Force Determines distance operator is
required to move steering wheel to disengage. High
setting will require more steering wheel motion before
disengagement. Use high setting when rough conditions
cause frequent disengagement of AutoTrac Universal.
SETUP
Steer Play Some vehicles may have excess play in their
steering system which allows the steering wheel to be
turned without change in the vehicle direction. This setting
will control the distance that the steering wheel turns in
order to take up this excess play. When ATU is placed on
a machine that has excess play this setting should be
used. This number should be set higher on vehicles which
require greater steering wheel movement before the
steering system responds. This setting should only be
used on vehicles with excess play in their steering
system. This number should be set to 0 on most vehicles
except windrowers.
IMPORTANT: Use AutoTrac Universal only on
Approved Vehicles – see
www.StellarSupport.com for list of
approved vehicles
It is important that the operator stay
seated while vehicle is moving.
When seat switch is chosen the
external seat switch must be plugged
into the AutoTrac Universal wiring
harness. If operator leaves the seat for
more than 7 seconds AutoTrac will be
disengaged.
When activity monitor is chosen
AutoTrac Universal will look for
operator activity every seven minutes.
Operator will get a time out warning 15
seconds before AutoTrac will
disengage. Pressing resume will reset
activity monitor timer.
PC8941 –19–21FEB06
OUO6050,0001AFA –19–20MAR06–5/5
25-4 032206
PN=10