AutoTrac Universal Addendum - StellarSupport - John Deere

Troubleshooting
Symptom Problem Solution
ATU constantly weaves in the StarFire Height or Fore-Aft not Enter correct StarFire Height and
row properly set Fore-Aft dimension
StarFire Receiver not in front of or Position StarFire in front of or even
even with Fixed Axle (Even with or with Fixed Axle (Even with or Behind
Behind for Articulated) for Articulated)
Line sensitivities incorrect. Optimize line sensitivities (See
OPTIMIZING AUTOTRAC
UNIVERSAL PERFORMANCE in
Setup section.)
StarFire mount direction in SETUP Correctly match TCM SETUP mount
different from actual mount direction direction to actual mount direction
Too much play in steering Check steering cylinder bushing; tie
mechanism rod ends, etc. for proper tolerance.
Increase steer play
ATU did not establish direction Drive forward at a speed greater
correctly than 1 mph and turn steering wheel
greater than 45 degrees in one
direction
Looseness or rotation in the Steering Insert shims to take out play in
console Steering console
Loose Soil Add Ballast
AutoTrac Universal won’t Stop Code encountered See list of stop codes to find issue
engage. AutoTrac will not
resume.
AutoTrac Universal does not System not recognizing AutoTrac Ensure AutoTrac Universal is
appear on INFO or SETUP Universal on CAN bus line connected to GreenStar Harness
screens and receiving power
Continued on next page
Check for blown fuses in ATU wiring
harness
OUO6050,0001B03 –19–20MAR06–2/3
80-2 032206
PN=16