System Manual SIMOCODE pro Edition 03/2007

1.7.3 Operator Panel with Display (OPD) for SIMOCODE pro V
System Description
Apart from the standard operator panel (OP), an optional operator panel with
display (OPD) is also available for SIMOCODE pro V. This operator panel can
display current measured values, operating data, diagnostic data or status
information of the motor feeder on the switchgear cabinet. The operator
panel can only be used with a basic unit 2 (SIMOCODE pro V) from product
version *E03*. It contains all the basic device status LEDs and facilitates
access to the system interface outside the switchgear cabinet. The motor
can be controlled via the buttons on the operator panel. Current measured
values, status information, fault messages or the device-internal error
protocol are simultaneously shown on the display.
Notice:
The operator panel can only be used with a basic unit 2 (SIMOCODE pro V)
from product version *E03*.
The following are available:
4 freely parameterizable buttons for controlling the motor feeder
4 buttons for display menu navigation, 2 of these are softkeys with various
functions (e.g. Test/Reset)
1 graphic display
7 LEDs, 4 of which are freely-parameterizable (4 green LEDs integrated in the
motor control, primarily for feedback regarding the switching state, e.g. ON,
OFF, LEFT, RIGHT, etc.)
The following figure shows an operator panel with display:
Operator panel with display
Fig. 1-10: Operator panel with display
Device series
SIMOCODE pro V
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 02 1-27