ELECTRIC ACTUATORS - YOO SHIN E&I CO., LTD.
ELECTRIC ACTUATORS - YOO SHIN E&I CO., LTD.
ELECTRIC ACTUATORS - YOO SHIN E&I CO., LTD.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
8<br />
USER’S<br />
GUIDE<br />
CHOOSING<br />
THE RANGE<br />
Operation type<br />
The requirements of the process determine the<br />
characteristics of an actuator.<br />
A modulating actuator has to be fully adapted to<br />
the duty given by the modulating loop. According to<br />
the duty or the function frequency, the actuator<br />
technology and its cost will be different.<br />
Within the range of actuators produced by L.<br />
BERNARD, the users can choose among four<br />
types of operation.<br />
ON/OFF<br />
● The actuator has been designed to operate from<br />
an extreme position to another with intermediate<br />
positions, if needed.<br />
● The motor is capable of starting 360 times per<br />
hour with a duty cycle of 30% and an ambient<br />
temperature under 40°C. This rate decreases<br />
when temperature rises.<br />
● The actuator is capable of performing approximately<br />
15 to 20 operations a day.<br />
CLASS III MODULATING<br />
Open<br />
Close<br />
CLASS III<br />
Time<br />
● The actuator is able to reach an intermediate<br />
position with a sufficient precision (better than<br />
2%).<br />
● The motor is able to start 1200 times per hour<br />
with a duty cycle of 50%, as to say a start every<br />
3 seconds. This starting frequency allows the<br />
process to stabilise a position, but shall not be<br />
kept permanently.<br />
● A class III actuator is designed for an average of<br />
360 changes of position a day.<br />
Technology : A class III actuator is selected in the<br />
On/Off actuators range.<br />
CLASS II MODULATING<br />
Open<br />
Close<br />
● The actuator is able to reach an intermediate<br />
position with a good precision (better than 1%).<br />
● The motor is able to start 1800 times per hour<br />
with a duty cycle of 100%.<br />
● A class II actuator is designed to move every 2 or<br />
3 seconds.<br />
Technology : Actuator with high mechanical efficiency,<br />
special modulating motor, solid state relay<br />
control.<br />
CLASS I MODULATING<br />
Open<br />
Close<br />
CLASS II<br />
CLASS I<br />
Time<br />
Time<br />
● The actuator is able to reach an intermediate<br />
position with a precision of 0,5% or better.<br />
● The actuator can move the valve, full stroke, very<br />
quickly.<br />
● A class I actuator is designed to move permanently.<br />
Technology : Actuator with high mechanical efficiency,<br />
brushless electric motor with speed regulation.