Installation instructions Toyota Corolla - Funkwerk Dabendorf GmbH

More documents

Recommendations

Info

5.6 EGO TS Functional Test An operational test is only possible after coupling the system with a Bluetooth ® - compatible device. The procedure is explained in the sections „5.8. Getting started“. 5.7 Symbols The control console of the EGO TS has a total of 4 keys. The illustration on the right shows an overview of the key locations. The functions of the individual keys are explained in the following section. 5.7.1 Key functions → The -key (green) is for accepting calls. It also controls the redial function, private mode and connect manually. → The -key (red) is used for rejecting incoming calls and ending completed calls (hang-up). It also controls the starts the phone‘s voice dialling function. → The -key increases the volume in phone. → The -key decreases the volume in phone.
5.8 Getting started Take enough time to familiarise yourself with the use of the system in combination with your phone. First of all, make a few calls to determine the ideal volume and the best voice pick-up direction before using the system in traffic. The best way of optimising conditions of use is to park your car in a quiet place especially for this purpose. It is also helpful if another phone user can take some time to assist you when making test calls. 5.8.1 On / Off function Turning the ignition key simultaneously activates the hands-free system. Immediately after the system is activated, the two LEDs blink 4 times. This indicates that the system is in standby mode and ready to make a connection. In order to use the system for phone calls, a Bluetooth ® compatible phone must be coupled to the EGO TS system. How this is done is explained in detail in the following sections. When the ignition is turned off, the hands-free system also shuts down. If the ignition is turned off during a call, phone ability is maintained and the system is shut down only after the call has been completed. 5.8.2 Coupling - As long as no device is connected, the system is visible for all Bluetooth - The device to be used (mobile phone, PDA, etc.) must be logged in to the system. The Bluetooth ® search and coupling are carried out by the device. The name of the system is EGO TS. - The PIN has a default setting of 0000. - Bei erfolgreicher Verbindung/Kopplung leuchten beide LED‘s dauerhaft. ® - It can be 8 Bluetooth phones be connected. ® devices. 5.8.3 Automatic coupling If a phone is already connected with the system, the EGO TS tries to couple to this phone. When a connection has been successfully made, the two LEDs are permanently on. The connection is always made to the most recently coupled phone. If this phone is out of range, the system will search for other phones registered in the system. When the search is successful, the connection to this phone is completed automatically. If the search process was unsuccessful, the system reverts to the coupling mode. This enables manual connection from the phone. 5.8.4 - - - LED status Green blinks in short intervals → no device connected Both permanently on → device is connected Red on and green blinks periodically → active call 14 | 15
Page 1 and 2: 128 8224 1.02 GB English Installati
Page 3 and 4: 1 Introduction / Preface Congratula
Page 5 and 6: 3 Conformity statement This equipme
Page 7 and 8: 5 5.1 - - - Installation instructio
Page 9 and 10: 5.3 5.3.1 Mounting Components DAMAG
Page 11 and 12: 2. 3. 4. Remove the front panel. No
Page 13: 8. Lay the microphone at a convenie
Page 17 and 18: 7 Spares Spares and accessories À
Page 19 and 20: 10 Hotline Any questions or suggest

Installation instructions Toyota Corolla - Funkwerk Dabendorf GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?