Installation instructions Toyota Corolla - Funkwerk Dabendorf GmbH

More documents

Recommendations

Info

Suitable locations for the electronics box: - Passenger side, next to the centre column under the panelling, modelspecific installation console (dealer) - Our suggested installation locations are shown in the illustration on the right Further unsuitable locations are: Leg and knee height, potential head impact zone, airbag inflation space, engine compartment 5.2.3 EGO TS Selection of the point of installation for the microphone Suitable for the microphone: - where voice can reach the microphone unhindered (distance between the speaker and the microphone should be approx. 35 cm), on the A-column (between windscreen and side window), next to the driver‘s sun visor, on the dashboard The illustration shows one of the potential microphone mounting locations. Alternatively, the microphone may be attached to the sun visor with the clip provided. Unsuitable for the microphone: -Close to the speakers (less than 80 cm), under the dashboard, in the air stream from open windows or ventilator outlets
5.3 5.3.1 Mounting Components DAMAGE TO ESSENTIAL VEHICLE COMPONENTS! Essential vehicle components or wiring can be damaged when drilling mounting holes or screwing in self-threading screws. Please make sure there is always sufficient space behind the screw holes and drilled holes! Mounting the electronics box Define the mounting points Making sure that there is at least 70 mm space for the plug and socket connectors. Mark the positions for the fixing screws. Mounting the electronics box For mounting the electronics box, use four self-threading screws and appropriate washers. We recommend size “ST 2,9x25 DIN 7981”self-threading screws. These are ideal for the fixing of the electronics box. Pre-drill the holes with a 2 mm drill. 5.3.2 Mounting the microphone Define the mounting location The microphone holder has a self-adhesive strip on the back. The mounting location should have the same form and area as the self-adhesive strip on the microphone holder. The location selected must allow the microphone cable to reach the electronics box! Locate the microphone with its head in the direction of speech. Cleaning and degreasing the mounting location The mounting location must be clean and free from grease and dirt/dust. Clean the proposed area with a cleansing product such as methylated spirits. Only use cleansing products that do not damage plastics or varnished wood finishes and are themselves free of oils or grease. Unsuitable cleansers are, for example,: lighter fluid, acetone, turpentine, trichloroethylene and similar products. Attaching the microphone holder Peel off the protective backing from the self-adhesive strip. Hold the microphone holder at a distance of several millimetres above the desired mounting location. Recheck the positioning. Repositioning after mounting is no longer possible. Place the microphone holder on the mounting location and fix by applying short and light pressure. Attaching the microphone 130 mm Attach the microphone by sliding it into the holder and orientate the microphone head in the direction of speech. 45 mm 70 mm 8 | 9
Page 1 and 2: 128 8224 1.02 GB English Installati
Page 3 and 4: 1 Introduction / Preface Congratula
Page 5 and 6: 3 Conformity statement This equipme
Page 7: 5 5.1 - - - Installation instructio
Page 11 and 12: 2. 3. 4. Remove the front panel. No
Page 13 and 14: 8. Lay the microphone at a convenie
Page 15 and 16: 5.8 Getting started Take enough tim
Page 17 and 18: 7 Spares Spares and accessories À
Page 19 and 20: 10 Hotline Any questions or suggest

Installation instructions Toyota Corolla - Funkwerk Dabendorf GmbH

Create successful ePaper yourself

Delete template?

Save as template?