caution - GM Canada

Headlamp High/Low-Beam Changer
23(Headlamp High/Low-Beam Changer): Pull the
turn signal lever all the way toward you to change the
headlamps from low to high beam. Then release it.
Windshield Wipers
The windshield wiper control is located on the
multifunction lever on the left side of the steering wheel.
Turn the band with N on it to the following positions:
8 (Mist): For a single wiping cycle, hold the band
on mist until the wipers start, then let go. The wipers
will stop after one wipe. If more wipes are needed,
hold the band on mist longer.
This instrument panel cluster light comes on when the
high beam headlamps are on.
Flash-to-Pass
This feature is used to signal to the vehicle ahead that
you want to pass.
If the headlamps are off or in the low-beam position,
pull the turn signal lever toward you to momentarily
switch to high-beams.
Release the lever to turn the high-beam headlamps off.
6 Delay: Turn the band to adjust the delay time between
wipes. The closer to the top of the lever, the shorter
the delay.
d (Low Speed): For steady wiping at low speed.
a (High Speed): For steady wiping at high speed.
9 (Off): Turns the wipers off.
When driving during the day and the wipers are
activated, the head lamps automatically turn on after
completing eight wipe cycles.
Be sure to clear ice and snow from the wiper blades
before using them. If they are frozen to the windshield,
carefully loosen or thaw them. If the blades become
damaged, get new blades or blade inserts.
3-8