TT225 StageIII+ Installation Manual.pdf - APR
TT225 StageIII+ Installation Manual.pdf - APR
TT225 StageIII+ Installation Manual.pdf - APR
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
INSTALLATION GUIDE<br />
1. Remove ECU and have <strong>APR</strong> inscription module and software installed.<br />
2. Drain coolant and oil.<br />
3. Remove air box and battery to gain better access to components during installation.<br />
4. In order to gain better access to the area behind the motor, remove the front axles and pendulum<br />
motor mount. Also remove the drive shafts and sub-frame. This will allow the motor to be rocked back<br />
when needed, using the upper motor mounts as a hinge. This should give you enough room to install<br />
the turbo and it’s associated plumbing.<br />
5. Remove turbo inlet plumbing. Remember to set aside the boost frequency valve, crank case vent<br />
valve, and diverter valve to be reused later.<br />
6. Remove turbo exit plumbing including the pipe crossing over the engine. Remember to set aside the<br />
bridge clamps to be reused later.<br />
7. Remove exhaust and drive shaft.<br />
8. Remove turbo with coolant and oil lines. All four lines will be replaced.<br />
9. Remove front bumper and headlights.<br />
10. Remove both intercoolers and associated brackets.<br />
11. With the supplied gasket and hardware in bag 1, install the <strong>APR</strong> exhaust manifold. Torque nuts to<br />
25nm/19ft-lbs.<br />
AUDI PERFORMANCE & RACING<br />
1027-B Opelika Road Auburn Alabama 36830