Tender Notice No: . VRTD/09/2013. - Gujarat Electricity Board

3.23 T & P physical Check. (Healthiness and Quality)
(a) P.P.rope. (b) Wire rope and sling. (d) Earthling rode
3.3 If above-mentioned safety requirements found violated in any of the above three
conditions shall attract penalty of Rs. 1000/- per occasion. (Max.Rs.3000/-- for violation
of three conditions)
3.4 During subsequent visit, if violation is found, then double penalty shall be deducted
from the bill of the contractor/Agency.
46. Safety guide for Contractors during work
In spite of safety measure & guide lines by GETCO regarding safety for contractor’s
labour, accidents are continued to occur to contractor’s labours. In this condition please
ensure following guidelines while working on lines.
1. The method of work required T&P and man power should be discussed between
GETCO supervisor, contractor’s supervisor and gang leaders.
2. Prior to execution of work a joint survey must be conducted by GETCO supervisor,
contractor’s supervisor and DISCOM line man in order to identify the following:
• HT/LT line or tap line crossing under each span of line of the work.
• Isolation point of each line crossing must be checked.
• Each line crossing & isolation point under each span must be discussed and
noted in maintenance register with sketch.
3. While execution of stringing work the identified line crossing must be isolated / deenergized
and written clearance should be obtained from concerned DISCOM
supervisor.
4. The isolation of Tap line must be physically seen and verified by contractor.
5. Contractor’s supervisor must take LCP for EHV line and power line crossing.
6. At D.O. fuse junction contractors person should be posted to ensure that no person
restore D.O supply while work is under execution.
7. Contractor’s supervisor must ensure all isolation physically prior to give clearance to
gang leader for talking up job.
8. Earthling must be done at the place of work before execution of any work.
9. Live line Detector should be used to check de-energisation of line before start of
work.
10. Earthing materials and tools of contractor shall be verified before starting of work.
11. No work by contractor labour without their supervision.
The above guidelines along with safety instruction as per annexure: A is attached
herewith shall be scrupulously implemented and this shall be part of the contract.
Page 34 of 78