(CIVIL, INTERIOR, ELECTRICAL & ALLIED WORKS) - Imimg

44
HARDWARES, CLAMPS ETC. SHALL BE REMOVED TO MAKE SURFACE CLEAN. MINIMUM
TWO OR MORE COATS OF THE LAPI / PUTTI SHALL BE APPLIED TO GET EVEN SURFACE
IN ENTIRE LINE & LEVEL. FINALLY 2 OR MORE COATS OF DISTEMBER PAINT SHALL BE
APPLIED OF SUGGESTED SHADE TO BE APPLIED WITH ROLLER FINISH AND FINISH TO
GET THE EVEN AND SATISFACTORY RESULT, THROUGHOUT THE WORK. THE AREA FOR
THE LIGHT FIXTURES, A.C. DIFFUSERS, COLUMNS ETC. WILL NOT BE CONSIDERED FOR
THE MEASUREMENT PURPOSE. ALL THE UNWANTED ELEMENTS SHALL BE REMOVED
FROM THE CEILING, WALL ETC. ONLY ONSITE EXECUTED AREA WILL BE CONSIDERED
FOR TE MEASUREMENT PURPOSE
5.0 P & A SATIN FINISH ENAMEL PAINT
P & A TWO & MORE COATS OF ENAMEL PAINT (SATIN FINISH) ON
EXISTING WINDOWS / GRILLS ETC. BY BRUSH, AT ALL LEVELS WITH FULL LAPI
COAT (THE RATE SHALL INCLUDE FOR ALL LADDERS SCAFFOLDINGS AND
SUPPORTS) FOLLOWING THE MANUFACTURERS SPECIFICATION. THE OLD
PAINT HAS TO BE REMOVED / SCRAPED PROPERLY. THE SURFACE SHALL BE
THROUGHLY CLEANED, DRIED AND MADE FREE OF ALL LOOSE DIRT, CHALK,
GREASE, FUNGUS AND ALAGE, WAX OR FLANKING PAINT. THE
COMPLETESURFACE PREPARATION SHALL BE DONE BY FILLING THE
SMALLER / LARGER CRACKS, BY PUTTI PROPERLY. FOR STEEL ELEMENTS,
THE REQUIRED COATS OF RED OXIDE SHALL BE APPLIED FOR PUTTING THE
PAINT. AND FINALLY 2 OR MORE COATS OF ENAMEL PAINT SHALL BE APPLIED
OF SUGGESTED SHADE AND FINISH TO GET THE EVEN AND SATISFACTORY
RESULT, THROUGHOUT THE WORK. FOR EACH ITEM THE MODE OF
MEASUREMENT WILL CONSIDERED SEPRATELY. ONLY ONSITE EXECUTED
AREA WILL BE CONSIDERED FOR MEASUREMENT PURPOSE.
5.0 Vitrified Flooring
PROVIDING & LAYING 1 ST QUALITY, PLAIN COLORED GRANAMITE TILES IN
FLOORING OF SIZE 2’ X 2’, IN SHADE AS MENTIONED. IT SHOULD BE PROVIDED IN
FLOOR IN COMPLETE LINE & LEVEL (NO GRADIENT) BY PROVIDING SUFFECIENT
THICKNESS (AS PER THE REQUIRMENT OF THE SITE) 30TO 45 MM C.M. 1:6 AS
BEDDING MATERIAL OR BY PUTTING TILE FIXING CHEMICALS OF MINIMUM 6 MM
THICKNESS ON THE EXISTING FLOOR AS PER THE SITE CONDITION & BANK’S
DECISION. THE JOB INCLUDES JOINT FINISHING WITH THE HELP OF WHITE
CEMENT, CEMENT COLOR, WITH JOINT FILLER OF APPROVED MAKE, CLEANING
ETC. COMPLETE. THE SHADE, DESIGN, THICKNESS AND SIZE OF THE TILES
SHOULD BE UNIFORM. THE TILES ARE TO BE FIXED IN SUGGESTED PATTERN,
JOINED WITH SUGGESTED COLOR CEMENT SLURRY IN JOINTS. PROPER FIXING
LEVEL SHOULD BE MAINTAINED. FULL PIECES HAVE TO BE FIXED EXCEPT WHERE
SMALL PIECES ARE NECESSARY. SMALL PIECES ARE TO BE AVOIDED AS FAR AS
POSSIBLE. THE JOB INCLUDES FIXING WHITE TAP ON JOINTS OF THE TILES,
LAYING 3 MM THICK FLOOR BUBBLE GUARD AFTER LAYING THE TILES AND
REMOVING THE SAME AFTER COMPLETION OF THE ENTIRE WORK INCLUDING ALL
OTHER AGENCIE’S WORK. ACTUAL ON SITE LAID QUANTITY WILL BE CONSIDERED
FOR THE MEASUREMENT PURPOSE. 10 % COLOURED TILES FOR DESIGN SHALL
BE CONSIDERED IN THE TOTAL QUANTITY.
Tender Document UBI Deva branch