GlowFit â a new tool for thermoluminescence glow curves doconvo

More documents

Recommendations

Info

Appendix A GlowFit manual
1. Introduction This software was designed using C++Builder 6 and runs under Windows environment. The best resolution is 1024x768 or higher with small fonts. Distribution disk contains executable file, GlowFit.exe, and two example pattern files. GlowFit analyses previously recorded measurements of TL glow-curves. Data files should be ASCII files of a maximum of 1000 lines, in the following columns format: • two columns: temperature (ºC) – intensity The main application window consists of two panels (Figure 1). Operational panel is used to open the data file, set the starting parameters as well as to adjust the parameters after fitting in case the fitting procedure failed. Fitted curve is presented on the screen in the results panel area. The area of each glow peak, FOM value, the residue and number of iterations needed to fit the glow-curve are also shown in this panel. Figure 1. The main application window of the GlowFit software. A1
Page 1 and 2: The Henryk Niewodniczański INSTITU
Page 3 and 4: a + a x + a x + a x + x 2 3 4 0 1 2
Page 5 and 6: Table 1. Comparison of FOM [%] valu
Page 7 and 8: Figure 2. Examples of glow-curves i
Page 9: 13. Bilski, P., Budzanowski, M. and
Page 13 and 14: The report and the plot files are t
Page 15 and 16: 4.3 The fixing of the peak paramete
Page 17: 7. Overview Button FIT Constraints

GlowFit â a new tool for thermoluminescence glow curves doconvo

Create successful ePaper yourself

Delete template?

Save as template?

GlowFit â a new tool for thermoluminescence glow curves doconvo