Kinwald Edition XXX - Team Losi Racing

Figure 22
BAG C (Continued)
22
27 67 69
! Step 16. Thread a bluish ball stud (22) into the outer hole in
the right rear hub (65), from the front (the side without the recessed
area) as shown in Figure 22.
IMPORTANT NOTE: Do not overtighten the ball studs.
! Step 17. Place a "foam thing" (47) over the ball stud (22).
! Step 18. Press a 3/16" x 3/8" sealed bearing (27) into the
inside of the right rear hub (65). Slide a rear axle (62) through the
bearing (27) in the rear hub (65).
*NOTE: If the 3/16" x 3/8" bearing only has one Teflon seal
(colored, woven-looking) in it, position the seal to the outside of the hub.
! Step 19. Slide an inner rear axle spacer (67) over the rear
axle (62) — from the outside — against the inside of the
bearing (27). Place a second 3/16" x 3/8" bearing (27) over the
rear axle (62) and press the bearing (27) into the outside of the
rear hub (65).
*NOTE: If the 3/16" x 3/8" bearing only has one Teflon seal
(colored, woven-looking) in it, position the seal to the outside of the hub.
! Step 20. Place an outer rear axle spacer (68) over the rear
axle (62), against the outside bearing (27). The small side of the
spacer (68) should be positioned next to the bearing (27).
! Step 21. Secure the rear axle (62) and the spacer (68) by inserting
a 1/16" x 7/16" spirol pin (69) through the small hole in
the rear axle (62). The pin (69) should be centered in the rear
axle (62).
! Step 22. Repeat Steps 16-21 for the left rear hub (66).
68
27
67
65
22
Figure 22
27
62
69
47
10