Kinwald Edition XXX - Team Losi Racing
Kinwald Edition XXX - Team Losi Racing
Kinwald Edition XXX - Team Losi Racing
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Figure 33<br />
BAG D (Continued)<br />
84 85 86 88<br />
! Step 12. Locate the diff adjusting screw (84) and place the<br />
foam thrust bearing seal (85) over the shoulder of the screw (84)<br />
next to the head.<br />
! Step 13. Place one of the 3mm x 8mm thrust bearing<br />
washers (86) over the diff screw (84).<br />
*NOTE: The thrust bearing washers are packaged in a small bag<br />
along with the eight 5/64" thrust bearing balls.<br />
! Step 14. Grease the thrust washer (86) well with white thrust<br />
bearing/assembly grease (87) and place the eight 5/64" thrust<br />
bearing balls (88) on top of the washer (86), around the diff screw<br />
(84). Apply more white thrust bearing/assembly grease (87) to<br />
the tops of the thrust bearing balls (88). Place the second thrust<br />
washer (86) over the screw (84) and against the thrust bearing<br />
balls (88).<br />
! Step 15. Very carefully insert the diff screw (84), with the<br />
thrust bearing assembly installed, into the outdrive (77). Be very<br />
careful not to bend or pinch the shim (83) while inserting the diff<br />
screw (84). Pull the threaded end of the diff screw (84) until the<br />
thrust bearing assembly rests against the shim (83) and bearing<br />
(80) inside of the outdrive (77).<br />
86<br />
GREASE<br />
84<br />
88<br />
85<br />
77<br />
IMPORTANT NOTE: Ensure that all eight thrust bearing<br />
balls remain in place between the two washers, around the diff<br />
screw.<br />
Figure 34<br />
Figure 33<br />
79<br />
79<br />
! Step 16. Locate the smallest of the Allen wrenches (74) and<br />
place it through the slot in the outdrive/diff half (77) containing<br />
the diff screw (84). Slide the wrench all the way against the screw<br />
(84). By handling the outdrive/diff half (77) with the wrench<br />
inserted, the diff screw (84) will be held in place while finishing<br />
assembly of the differential.<br />
! Step 17. Apply a small amount of clear diff grease (78) to the<br />
outer ridge of the outdrive (77). Install the remaining diff washer<br />
(79), again lining up the flat sections of the outdrive/diff half (77)<br />
with the flat sections in the washer (79). Apply a fairly heavy coat<br />
of grease (78) to the exposed side of the diff washer (79).<br />
84<br />
77<br />
74<br />
SMALLAMOUNT<br />
OF GREASE<br />
Figure 34<br />
14
Change language