Contents Contents - RELM Wireless

KNG Portable Radio User’s Manual
Tx Frequency
Enter a valid receive frequency in MHz. Frequencies must be
divisible by 1.25kHz.
Tx Mode
Select Analog, Digital or Selectable.
Tx Guard
Analog or Mixed Mode Receive Channels Only
Select “Off” for analog signals to operate in carrier squelch mode.
Select “Tone” to enter a CTCSS tone,
Select “Digital” to enter a DCS value.
Use “INV” to invert a DCS tone.
Tx NAC
Analog or Mixed Mode Transmit Channels Only
Select “Enter” to program a transmit NAC via the keypad.
Enter the desired value in hexadecimal (000 - FFF).
NOTE: $F7E and $F7F are invalid transmit NACs.
Choose “Select” to use a transmit NAC from the pick list.
TGID
Analog or Mixed Mode Channels Only
Select “Enter” to program a transmit Talk Group ID via the keypad.
Enter the desired value (1- 65535).
NOTE: 0 is an invalid transmit Talk Group ID.
Choose “Select” to use a TGID from the pick list.
P25 ID Unit Call/Receive List
The KNG can be pre-programmed with up to 100 Project 25 IDs and
labels. If ‘RX’d Unit ID’ is designated as a display line, the P25 ID of
the radio sending the call will be shown when receiving a digital signal.
If the P25 ID of the received call is programmed in the Call List, the
alphanumeric label associated with the ID will be displayed. If the P25 ID
is not in the Call List, the numeric P25 ID will be displayed.
- 53 -