Technical Rider Hell on Earth - Key Performance

CONSTANZA MACRAS | DORKYPARK - “HELL ON EARTH” PAGE2of10
TECHNICAL REQUIREMENTS
General description of the set
The set consists of a scaffold structure with wooden front and brown dance floor. Under
this structure there is a shower cabinet installed (water supply and drain are required).
We bring:
• The set, the props, the costumes.
We require:
STAGE
• Dimensions:
- 10m wide x 15m deep dancing area. As the wings are visible, the whole stage
must be empty and clean.
- Minimum height of the grid: 7 meters.
• Floor:
- A clean and even floor, covered with brown dance mat, 12m x 15m (we bring).
- 12 x 15m soft material to lay under the dance floor, 2-3mm thick - parquet
insulating underlay (extruded polystyrene heavy foam around 2.2 mm thick for
floating installation of laminate floors and prefabricated parquet), cork, foam rubber
or similar. A second dance floor underneath is also possible.
• Masking:
- 12m x 10m dark grey cyclorama, flat, no pleats and piped for a straight edge.
- Two black drops (full or in parts) to mask the sides (German masking).
• Goods:
- 1 platform 2m(w) x 2m(d) x 1m (h) to be used as part of the set.
- 1 ladder 5m high to access the higher platform of the set.
- Water supply (warm) and drain for the shower.
- 1 strip earth band + 10mm2 cable (the scaffold must be grounded/earthed).
- Basic theatre tools, battery drill, saw, etc.
- A forklift is necessary to load in and out.