You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Connecting an external control device<br />
REMOTE CONTROL jacks<br />
If this unit is installed in a location that is out of range of the signal<br />
from the remote control unit, you can still operate the unit and the<br />
devices connected to it by using a commercially available IR receiver.<br />
You can also use it to remotely control ZONE2 (another room).<br />
RS-232C connector<br />
When you connect an external control device, you can control this unit<br />
with the external control device.<br />
External serial controller<br />
AUX<br />
OUT<br />
Infrared<br />
retransmitter<br />
Input<br />
Infrared<br />
sensor<br />
Output<br />
Device equipped with a<br />
REMOTE CONTROL IN jack<br />
Perform the operation below beforehand.<br />
q Turn on the power of this unit.<br />
w Turn off the power of this unit from the external controller.<br />
e Check that the unit is in the standby mode.<br />
16
Change language