AT Commands Reference Guide - HW Kitchen

More documents

Recommendations

Info

AT Commands Reference Guide 80000ST10025a Rev. 5 - 09/07/08 Numeric Format Verbose Format 17 SIM PIN2 required 18 SIM PUK2 required 20 memory full 21 invalid index 22 not found 23 memory failure 24 text string too long 25 invalid characters in text string 26 dial string too long 27 invalid characters in dial string 30 no network service 31 network time-out 32 network not allowed - emergency calls only 40 network personalization PIN required 41 network personalization PUK required 42 network subset personalization PIN required 43 network subset personalization PUK required 44 service provider personalization PIN required 45 service provider personalization PUK required 46 corporate personalization PIN required 47 corporate personalization PUK required General purpose error: 100 unknown GPRS related errors to a failure to perform an Attach: 103 Illegal MS (#3)* 106 Illegal ME (#6)* 107 GPRS service not allowed (#7)* 111 PLMN not allowed (#11)* 112 Location area not allowed (#12)* 113 Roaming not allowed in this location area (#13)* GPRS related errors to a failure to Activate a Context and others: 132 service option not supported (#32)* 133 requested service option not subscribed (#33)* 134 service option temporarily out of order (#34)* 148 unspecified GPRS error 149 PDP authentication failure 150 invalid mobile class Network survey errors: (only if command #SELINT=0 or #SELINT=1 has been issued - see §3.5.2.1.1): 257 Network survey error (No Carrier)* 258 Network survey error (Busy)* 259 Network survey error (Wrong request)* 260 Network survey error (Aborted)* Easy GPRS® related errors (only if command #SELINT=0 or #SELINT=1 has been issued - see §3.5.2.1.1): 400 generic undocumented error 401 wrong state 402 wrong mode 403 context already activated 404 stack already active 405 activation failed 406 context not opened 407 cannot setup socket 408 cannot resolve DN Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 12 of 434
AT Commands Reference Guide 80000ST10025a Rev. 5 - 09/07/08 Numeric Format Verbose Format 409 time-out in opening socket 410 cannot open socket 411 remote disconnected or time-out 412 connection failed 413 tx error 414 FTP related errors already listening (only if command #SELINT=0 or #SELINT=1 has been issued - see §3.5.2.1.1): 420 ok 421 connect 422 disconnect 423 error 424 wrong state 425 can not activate 426 can not resolve name 427 can not allocate control socket 428 can not connect control socket 429 bad or no response from server 430 not connected 431 already connected 432 context down 433 no photo available 434 can not send photo Easy GPRS® related errors (only if command #SELINT=2 has been issued - see §3.5.2.1.1): 550 generic undocumented error 551 wrong state 552 wrong mode 553 context already activated 554 stack already active 555 activation failed 556 context not opened 557 cannot setup socket 558 cannot resolve DN 559 time-out in opening socket 560 cannot open socket 561 remote disconnected or time-out 562 connection failed 563 tx error 564 FTP related errors already listening (only if command #SELINT=2 has been issued - see §3.5.2.1.1): 600 generic undocumented error 601 wrong state 602 can not activate 603 can not resolve name 604 can not allocate control socket 605 can not connect control socket 606 bad or no response from server 607 not connected 608 already connected 609 context down 610 no photo available 611 can not send photo Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 13 of 434
Page 1 and 2: AT Commands Reference Guide GM862-Q
Page 3 and 4: Contents AT Commands Reference Guid
Page 5 and 6: DISCLAIMER AT Commands Reference Gu
Page 7 and 8: 2 APPLICABLE DOCUMENTS a) ETSI GSM
Page 9 and 10: 3.2 AT Command Syntax AT Commands R
Page 11: ATCMD1 CMD2=10+CMD1;+CMD2=, ,10;+CM
Page 15 and 16: 3.2.3 Information Responses And Res
Page 17 and 18: AT Commands Reference Guide 80000ST
Page 21 and 22: +FCLASS +ILRR +DR +CSCS +CR +CRLP +
Page 23 and 24: 3.4 AT Commands Availability Table
Page 25 and 26: COMMAND GM862 - QUAD GM862- QUAD- P
Page 31 and 32: 3.5 AT Commands References 3.5.1 Co
Page 33 and 34: 3.5.2.1.1 Select Interface Style -
Page 55 and 56: 3.5.3.3.3 Pulse Dial - P AT Command
Page 63 and 64:
3.5.3.7.6 Command Line Editing Char
Page 65 and 66:
AT Commands Reference Guide 80000ST
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
+CBST - Select Bearer Service Type
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
3.5.4.3.9 Calling Line Identificati
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
3.5.4.3.12 Call Holding Services -
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
+CPIN - Enter PIN AT Commands Refer
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
3.5.5 ETSI GSM 07.05 AT Commands fo
Page 171 and 172:
Page 173 and 174:
+CPMS - Preferred Message Storage [
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
+CNMI - New Message Indications To
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
+CMGR - Read Message AT Commands Re
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
3.5.5.4 Message Sending And Writing
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
3.5.6 FAX Class 1 AT Commands 3.5.6
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
#CEER - Extended numeric error repo
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
3.5.7.1.20 Software Shut Down - #SH
Page 253 and 254:
Page 255 and 256:
AT#TEMPMON? #TEMPMEAS: , where: an
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
3.5.7.1.28 STAT_LED GPIO Setting -
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
: handset analogue output gain 0..6
Page 297 and 298:
Page 299 and 300:
3.5.7.1.70 Handset Noise Reduction
Page 301 and 302:
Page 303 and 304:
Page 305 and 306:
Page 307 and 308:
Page 309 and 310:
Page 311 and 312:
Page 313 and 314:
context AT Commands Reference Guide
Page 315 and 316:
Page 317 and 318:
Page 319 and 320:
3.5.7.3.5 Socket Configuration - #S
Page 321 and 322:
Page 323 and 324:
Page 325 and 326:
Page 327 and 328:
Page 329 and 330:
Page 331 and 332:
Page 333 and 334:
Page 335 and 336:
Page 337 and 338:
Page 339 and 340:
Page 341 and 342:
Page 343 and 344:
#DNS - Manual DNS Selection AT Comm
Page 345 and 346:
3.5.7.5.12 Socket Parameters Save -
Page 347 and 348:
Page 349 and 350:
Page 351 and 352:
Page 353 and 354:
Page 355 and 356:
Page 357 and 358:
Page 359 and 360:
Page 361 and 362:
Page 363 and 364:
Page 365 and 366:
Page 367 and 368:
Page 369 and 370:
Page 371 and 372:
Page 373 and 374:
Page 375 and 376:
3.5.7.6.10 SMTP Read Message - #EMA
Page 377 and 378:
Page 379 and 380:
Page 381 and 382:
Page 383 and 384:
Page 385 and 386:
Page 387 and 388:
Page 389 and 390:
Page 391 and 392:
Page 393 and 394:
Page 395 and 396:
Page 397 and 398:
Page 399 and 400:
Page 401 and 402:
Page 403 and 404:
Page 405 and 406:
Page 407 and 408:
Page 409 and 410:
Page 411 and 412:
Page 413 and 414:
Page 415 and 416:
Page 417 and 418:
Page 419 and 420:
Page 421 and 422:
Page 423 and 424:
Page 425 and 426:
Page 427 and 428:
Page 429 and 430:
Page 431 and 432:
4 List of acronyms AT Commands Refe
Page 433 and 434:
5 Document Change Log AT Commands R
show all

AT Commands Reference Guide - HW Kitchen

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?