Enano-8523T User Manual - iEi
Enano-8523T User Manual - iEi
Enano-8523T User Manual - iEi
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3.4 Onboard Jumpers<br />
NOTE:<br />
A jumper is a metal bridge that is used to<br />
close an electrical circuit. It consists of<br />
two metal pins and a small metal clip<br />
(often protected by a plastic cover) that<br />
slides over the pins to connect them.<br />
To CLOSE/SHORT a jumper means<br />
connecting the pins of the jumper with<br />
the plastic clip and to OPEN a jumper<br />
means removing the plastic clip from a<br />
jumper.<br />
Figure 1-3-20 Jumper<br />
The <strong>Enano</strong>-<strong>8523T</strong> board has three one onboard jumpers, “Clear CMOS,” “CF card setup”<br />
and “LCD voltage setup.”<br />
Figure 3-21: Jumper Locations<br />
58 IEI ® Technology, Corp.<br />
1-58