Raptor 30 V2 - DMT
Raptor 30 V2 - DMT
Raptor 30 V2 - DMT
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Preflight Checklist and Starting Procedure<br />
(1) Check to make sure there is no radio interfence before operating the model helicopter.<br />
(2) Make sure the transmitter and receiver are on and all controls operate properly before flight.<br />
Range check the radio.<br />
(3) The engine carburetor must be in the idle position before starting the engine. Please read<br />
the engine instruction manual on how to properly adjust the engine. Set the carburetor main<br />
needle according to the engine instruction. Depending on the fuel and glow plug used, the<br />
carburetor idle screw may require fine adjustment of 1/4 to 1/2 turn away from the factory<br />
setting.<br />
(4) Fill the fuel tank, move the throttle stick to idle, and connect the glow plug battery to the glow<br />
plug.<br />
(5) Use a 12 volt electric starter along with<br />
a 6 mm hex starter extension (sold<br />
seperately) to start the engine.<br />
*A lw a ys g r ab on th e<br />
helicopter main rotor head<br />
when starting the engine.<br />
Otherwise, the main rotor<br />
may start spinning<br />
immediately after the<br />
engine is started.<br />
24