Raptor 30 V2 - DMT

More documents

Recommendations

Info

Flying Adjustments (1) Tracking adjustment ... When the two main rotor blades are in track it means their blade tips should follow the same path as they rotate. (1) Rev up the motor until the helicopter becomes light on its skids. Stand about 15 feet(4 meters) alway from the helicopter. (2) When the two main rotor blades are in track it means the blade tips should follow the same path as they rotate. increase throttle gently and not too much (3) When both blades are in track, the blade tips will appear to overlap as seen from the edge of the rotor plane. out of track If the blades are out of track, then adjust one of the pushrods that connects to the main rotor blade pitch arm. Redo steps (1) to (3) until the blades are tracking properly. in track In hover, the main blades should be around 5.5 to 6 degrees in pitch. 25
Flying Adjustments (2) Trimming: All helicopters are inherently unstable. But when a helicopter is properly trimmed, it will not drift away or yaw by itself quickly. Use the following procedure to trim your helicopter. (1) If the helicopter nose starts to yaw left or right, then use the transmitter trim to compensate: yaw right yaw left (A) situation: move to (b) (B) situation: move to (a) (2) If the helicopter rolls to left or right, then: rolls right rolls left (C) situation: move to (d) (d) situation: move to (c) (3) If the helicopter noses down or up, then: Noses down Noses up (E) situation: move to (f) (F) situation: move to (e) 26
Page 2 and 3: INTRODUCTION Congratulations on you
Page 4 and 5: RADIO SET OTHER ITEMS REQUIRED Rece
Page 6 and 7: 1 Fuel Tank Assembly Note: After as
Page 8 and 9: 4 Main Drive Gear Assembly (2) HMQ1
Page 10 and 11: 7 Main Frame Assembly-Part3 Insert
Page 12 and 13: 11 Main Rotor Head Assembly Assembl
Page 14 and 15: 14 Tail Boom Assembly Assembly Tip:
Page 16 and 17: 17 Servo Installation-Part2 Assembl
Page 18 and 19: Setting up Main Rotor Blades Pitch
Page 20 and 21: Collective Travel for F3C and 3D Fl
Page 22 and 23: Engine Throttle Control Linkage Mou
Page 24 and 25: Preflight Adjustments Relationship
Page 28 and 29: Hover Training (1) Hovering is when
Page 30 and 31: Forward Flight Training After maste
Page 32 and 33: After Flight Checklist (1) Check ev
Page 34 and 35: Changing the tail drive belt: (1)Lo
Page 36 and 37: Blade Modification Idea and origina
Page 38 and 39: PV0486 Flybar Seesaw AK0029 Main Sh
Page 40 and 41: PV0048 Pitch Frame/Rotor Hub Seesaw
Page 42 and 43: PV0366 Decal PV0367 Pinion Gear (9T
Page 44 and 45: Parts No. Description Item No. Desc
Page 46 and 47: Parts No. Description Item No. Desc
Page 48 and 49: HELICOPTER ACCESSORIES NO. 3800 BLA

Raptor 30 V2 - DMT

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?