KD-G333/KD-G332/KD-G331 - JVC Multilingual Service Information ...
KD-G333/KD-G332/KD-G331 - JVC Multilingual Service Information ...
KD-G333/KD-G332/KD-G331 - JVC Multilingual Service Information ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
ELECTRICAL CONNECTIONS<br />
A<br />
Typical connections<br />
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.<br />
The leads of the power cord and those of the connector from the car body may be different in color.<br />
1 Connect the colored leads of the power cord in the order specified in the illustration below.<br />
2 Connect the antenna cord.<br />
3 Finally connect the wiring harness to the unit.<br />
B<br />
Rear ground terminal<br />
White with black stripe<br />
Antenna terminal<br />
Line out (see diagram )<br />
White<br />
Left speaker (front)<br />
Gray with black stripe<br />
Connecting the external amplifier or subwoofer<br />
15 A fuse<br />
Black<br />
Yellow * 2<br />
Blue with white stripe<br />
Gray<br />
Right speaker (front)<br />
To metallic body or chassis of the car<br />
To a live terminal in the fuse block connecting to the car battery<br />
(bypassing the ignition switch) (constant 12 V)<br />
To an accessory terminal in the fuse block<br />
Green with black stripe<br />
* 1 Not supplied for this unit.<br />
* 2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.<br />
* 3 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.<br />
* 4 Signal cord (not supplied for this unit).<br />
2<br />
To the automatic antenna if any (250 mA max.)<br />
You can connect an amplifier to upgrade your car stereo system.<br />
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.<br />
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.<br />
Set “L/O MODE” to “REAR” (See page 12 of the<br />
INSTRUCTIONS.)<br />
You can connect a power amplifier for rear speakers.<br />
Rear speakers<br />
Subwoofer<br />
<strong>JVC</strong> Amplifier<br />
Set “L/O MODE” to “WOOFER” (See page 12 of the<br />
INSTRUCTIONS.)<br />
You can also connect a subwoofer to the REAR LINE OUT<br />
terminals.<br />
<strong>JVC</strong> Amplifier<br />
or<br />
Red<br />
Blue<br />
Remote lead<br />
To the remote lead of other equipment (200 mA max.)<br />
Green<br />
Left speaker (rear)<br />
Remote lead (blue with white stripe)<br />
Purple with black stripe<br />
Ignition switch<br />
Fuse block<br />
Purple<br />
Right speaker (rear)<br />
Y-connector (not supplied for this unit)<br />
To the remote lead of other equipment or automatic antenna if any<br />
Front speakers
Change language