SANMOTION Q - Sanyo Denki America, Inc.
SANMOTION Q - Sanyo Denki America, Inc.
SANMOTION Q - Sanyo Denki America, Inc.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MODE<br />
T<br />
S<br />
R<br />
t<br />
r<br />
-<br />
DL1<br />
DL2<br />
P<br />
RB1<br />
RB2<br />
W<br />
V<br />
U<br />
CHARGE<br />
C<br />
N<br />
B<br />
C<br />
N<br />
C<br />
/WR<br />
POWER<br />
P<br />
C<br />
AC PF<br />
(2) Positioning Operation with Speed Variation (example)<br />
By starting up Point 1, Points 2 and 3 will be executed consecutively.<br />
Point Data Setup: Enables configuration and saving of parameters, and the reading of point data from a PC.<br />
Q1 QS AC Models<br />
PLC<br />
Starting Coordinates: Start-up Point 001 (P001) as 0.0<br />
Mode 1: [01]= Positioning Operation enabled; Mode 2: [00]= Final Travel, [01]= Continue to next Point Number<br />
Gear Change: Stop / Continue: [1]= Consecutive Gear Shift Operation<br />
N<br />
A<br />
C<br />
QS1A100A<br />
P001:100.0 P002:150.0 P003:180.0<br />
C<br />
N<br />
1<br />
C<br />
N<br />
2<br />
Pass Point 1 Move to Point 2 Move to Point 3<br />
-OT Sensor Deceleration Signal<br />
Sensor<br />
+OT Sensor<br />
Options DC Models Q2 Q4<br />
Setup<br />
Software<br />
Positionng<br />
General Spec<br />
Motor Speed<br />
Point Input<br />
Point 1 (P001) ON only<br />
CN1-42<br />
0.0 100.0 200.0<br />
ON<br />
OFF<br />
Coordinate<br />
Start-up Signal Input<br />
CN1-27 <br />
Running Output<br />
CN1-7 <br />
ON<br />
OFF<br />
ON<br />
OFF<br />
Positioning Completion Signal<br />
CN1-8 <br />
ON<br />
OFF<br />
42
Change language