D a t a S h e e t - SemiconductorStore.com

More documents

Recommendations

Info

9. WT12 PHYSICAL DIMENSIONS WT12-A Dimensions Tolerances +/- 10% 25.0 mm 20.0 mm < ant 14 mm 10.0 mm BLUEGIGA 0.5mm 5.0 mm PCB thickness 0.8mm 2.4 mm ant 2.0 mm ant 1.6 +/- 0.2 mm 3.2 +/- 0.2mm Figure 29: WT12 dimensions 47
Figure 30: WT12 foot print and dimension (top view) Figure 31: WT12 pad dimensions 48
Page 1 and 2: WT12 Data Sheet V e r s i o n 2 . 3
Page 3 and 4: Contents: 1. Block Diagram and Desc
Page 5 and 6: TERMS & ABBREVIATIONS Term or Abbre
Page 7 and 8: 1. BLOCK DIAGRAM AND DESCRIPTIONS F
Page 9 and 10: Since the details of some methods a
Page 11 and 12: Radio characteristics and general s
Page 13 and 14: 6. Measured at F0= 2441MHz. 7. Up t
Page 15 and 16: 2.2 Radio Characteristics - Enhance
Page 17 and 18: 3. WT12 PIN DESCRIPTION WT12 31 30
Page 19 and 20: CMOS input with weak internal pull-
Page 21 and 22: has to be connected to UART_RX. UAR
Page 23 and 24: 4.2 USB Interface WT12 USB devices
Page 25 and 26: USB_D+ WT12 USB_D- USB_ON VBUS Volt
Page 27 and 28: 4.3 SPI Interface The synchronous s
Page 29 and 30: PCM_OUT WT12 PCM_IN PCM_CLK Up to 2
Page 31 and 32: PCM_SYNC PCM_CLK PCM_OUT 1 2 3 4 5
Page 33 and 34: Name Bit position Description - 0 S
Page 35 and 36: 6. SOFTWARE STACKS WT12 is supplied
Page 37 and 38: The firmware has been written again
Page 39 and 40: 6.3 RFCOMM Stack RFCOMM SDP L2CAP H
Page 41 and 42: main WRAP THOR firmware. The user i
Page 43 and 44: 7. ENHANCED DATA RATE EDR has been
Page 45 and 46: 8. LAYOUT AND SOLDERING CONSIDERATI
Page 47: • Routing should be done in the i
Page 51 and 52: Figure 33: Tape information 50
Page 53 and 54: 11.2 FCC Federal Communications Com
Page 55 and 56: 12. ROHS STATEMENT WITH A LIST OF B

D a t a S h e e t - SemiconductorStore.com

Create successful ePaper yourself

Delete template?

Save as template?