Spa2Go Manual - Hot Tubs

15. Wrap the five inch wide vinyl power
pack connector cover around all three
connections between the power pack and
the spa.
User’s Guide
FILLING THE SPA
1. Ensure the power pack is not plugged in.
2. Remove the protective caps from the
suction and discharge fittings inside the
spa. Place the caps in a safe location.
3. Using a garden hose, fill the spa to
approximately one inch above the top
of the second air chamber ring. Be
careful not to over fill the spa, or the spa
may overflow during use. Each average
adult will raise the water level in the spa
approximately two inches, and the turbo
wave blower action will raise water level
an additional three to four inches.
4. Bleed the air from the filter tank by
turning the small black knob on the top
of the filter tank counterclockwise. Allow
the filter tank to bleed for approximately
one minute, or until water drips from
the fitting. Turn the fitting clock-wise to
close the bleed valve.
2”
Approx.
Fill Line
14