Mid-Mount Platform Manual
Mid-Mount Platform Manual
Mid-Mount Platform Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
OPERATION<br />
3-5.<br />
MANUAL OVERRIDE CONTROLS<br />
AWARNING<br />
Any time that an override or manual control is used, Abb safety systems are overridden.<br />
operator must be absolutely sure that all safety operating parameters are being met.<br />
The<br />
3-5.1 MANUAL STABILIZER CONTROL VALVES.<br />
The manual stabilizer override controls are located behind an access door in the left front step well. Opening the door<br />
will indicate to the Command Zone Information Center (CZIC) that an override is in progress; a message will ~<br />
displayed at the turntable display. <strong>Manual</strong>ly pushing or pulling on each of the handles will operate the stabilizer<br />
beams and jacks. A label indicating the function of each lever is attached to the inside of the door. Refer to Para 3-<br />
5.3, Emergency Pump Unit, for additional information on the operation of these control valves.<br />
A WARNING<br />
You must not operate these manual override controls unless:<br />
. You have been trained in the safe operation of this device;<br />
. You are aware of the aerial position. Raising a stabilizer jack may cause the truck to tip<br />
over.<br />
. You have a second person to monitor the positioning of the stabilizers that are not clearly<br />
visible.<br />
. You are aware that safety devices are being overridden.<br />
Death or serious injury may result if the above statements are not observed.<br />
.<br />
NOTE<br />
No automatic high idle is provided with the function of the manual controls.<br />
The manual override door must be closed at all times during normal operation.