Rane AD 22d Audio Delay data sheet - Talamas

AD 22d
AUDIO DELAY
Rear Panel
OPEN
REMOTE RECALL
MEM A
POWER
CLOSED
MEM B
650mA
CH1 CH2 GND
CLASS 2 EQUIPMENT
CH 2 OUT
CH 2 OUT
CH 2 IN
CH 2 IN
CH 1 OUT
CH 1 OUT
CH 1 IN
CH 1 IN
BALANCED WIRING:
PIN 2 POSITIVE
PIN 3 NEGATIVE
PIN 1 CHASSIS GND
REMOTE RECALL PORT:
5 VOLT SOURCES 0.5 mA
CMOS SCHMITT TRIGGER INPUTS
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
AD 22d
MADE IN U.S.A.
RANE CORP.
ACN 001 345 482
Architectural Specifications
The digital audio delay unit shall be a single rack space, two
input, two output configuration. The delay adjustment range
shall be from 1.50 to 999.99 ms, adjustable via increment/decrement
pushbuttons, in both 10 microsecond and 1 millisecond
intervals. Independent remote recall terminals shall be provided
for external recall of stored configuration memories, two per
channel. A five (5) digit LED display shall indicate delay values
in milliseconds, feet or meters as well as temperature setting and
software revision level. Bypass status, current memory, channel,
and display modes shall be indicated with individual indicators.
A recessed rear-panel switch shall disable the front panel, yet
still allow viewing of delay values.
Independent input-output sensitivity controls shall be
included to allow calibration of the input signal for maximum
performance. The inputs and outputs shall be active balanced
with XLR connectors. Each channel shall have indicators for
signal present and input/output clip conditions.
The unit shall provide independent, fail-safe bypass relays
requiring no power to engage. RFI filters shall also be provided.
The unit shall have certified compliance with FCC docket
20780 Part 15J for Class B computing devices. The AD 22d shall
comply with EMCD 89/336/EEC (CE approved). The 120 VAC
model shall be powered from a UL listed, CSA certified remote
power supply, and the 230 VAC model shall be powered from
a remote power supply meeting LVD 73/23/EEC and EMCD
89/336/EEC standards. The unit shall be constructed entirely
from cold-rolled steel.
The unit shall be a Rane Corporation AD 22d.
References
1. Shaw, N. “Digital Delays, Parts One, Two & Three,” Sound & Communications, vol. 39, nos. 3, 5 & 10, (March, May, & October 1993).
2. Bohn, D. “Environmental Effects on the Speed of Sound,”J. Audio Eng. Soc., vol. 36, pp. 223-231 (April 1988).
©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5098 TEL 425-355-6000 FAX 425-347-7757 WEB www.rane.com
Data Sheet- All features & specifications subject to change without notice. DOC 103488