Nexsys Modules - Crest Audio
Nexsys Modules - Crest Audio
Nexsys Modules - Crest Audio
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3<br />
p.10<br />
Features Overview<br />
Rear Panel - CKi 100s shown<br />
1<br />
Rear Panel<br />
2<br />
������<br />
3<br />
������������������<br />
��<br />
���<br />
���<br />
��<br />
���<br />
���<br />
�� ���<br />
����<br />
����<br />
��<br />
�����<br />
�����<br />
���<br />
���<br />
���<br />
���<br />
����������������������������������������<br />
�����������������<br />
������������������<br />
������������������<br />
� �<br />
+<br />
+<br />
���<br />
+<br />
���<br />
��<br />
���<br />
��<br />
������<br />
���<br />
�� ���<br />
��<br />
������<br />
���<br />
�������� �<br />
��<br />
��<br />
���<br />
�<br />
��<br />
��<br />
��� �����������������������<br />
����<br />
���� ����<br />
1 Mains Breaker<br />
2U & 3U amplifiers have a push-type circuit breaker, while 4U units have<br />
a throw-switch style breaker. If the unit’s breaker trips repeatedly, the<br />
amplifier needs servicing.<br />
2 IEC Power Cord Connector<br />
On 2U amplifiers, a standard IEC power connector is located on the<br />
rear panel of amplifier.The connector accommodates a standard IEC line<br />
cord, included in the amplifier box. Should this cord need to be<br />
replaced, only a cord with the same current rating should be used. 3U<br />
& 4U units have a captive power cord.<br />
3AC Mains / Active LED indicators<br />
The AC mains yellow LED indicates that the amplifier is attached to a<br />
power source.The active green LED indicates that the amplifier has been<br />
turned on and is operating.<br />
4 Sequential turn on/off Connectors<br />
These connectors can be wired to a contact closure for remote turnon<br />
and to other CKi amplifiers for sequential turn-on (STO).<br />
5 Fault I/O Connector<br />
This output is a contact closure that can be used to report a fault condition<br />
(e.g. an open output relay) in the amplifier.<br />
6<br />
+<br />
� �<br />
�������<br />
���<br />
���<br />
������<br />
���� ����<br />
+ +<br />
4 5 7 12 13<br />
8<br />
9<br />
0<br />
¡<br />
�����<br />
���<br />
�������<br />
���<br />
���<br />
����<br />
Rear Panel Legend<br />
Ground Connected<br />
Ground Lifted<br />
Channel A stereo/parallel<br />
Bridged mono<br />
Channel B stereo/parallel<br />
Input Polarity<br />
Never connect a hot<br />
(red) output to ground<br />
or to another hot (red)<br />
output!<br />
a